Components
COMPONENTS
ILLUSTRATION
Removal
REMOVAL
PROCEDURE
1. REMOVE NO. 2 ROOM LIGHT ASSEMBLY
(a) Using a moulding remover, disengage the claw. |
|
(b) Disconnect the connector and remove the No. 2 room light assembly.
Inspection
INSPECTION
PROCEDURE
1. INSPECT NO. 2 ROOM LIGHT ASSEMBLY
(a) Connect a positive (+) lead from the battery to terminal 1 and a negative (-) lead to terminal 2. |
|
(b) Check that the light comes on.
OK:
Light comes on.
Text in Illustration
*1 |
Component without harness connected (No. 2 Room Light Assembly) |
If the result is not as specified, replace the bulb or No. 2 room light assembly.
Installation
INSTALLATION
PROCEDURE
1. INSTALL NO. 2 ROOM LIGHT ASSEMBLY
(a) Connect the connector.
(b) Engage the claw to install the No. 2 room light assembly. |
|
Power Back Door Main Switch
Components
COMPONENTS
ILLUSTRATION
Inspection
INSPECTION
PROCEDURE
1. INSPECT POWER BACK DOOR MAIN SWITCH
(a) Check that the switch function.
(1) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
...
Crankshaft Position Sensor "A" Circuit (P0335,P0339)
DESCRIPTION
The crankshaft position sensor system consists of a crank angle sensor plate
and a pickup coil.
The sensor plate has 34 teeth and is installed on the crankshaft. The pickup
coil is made of wound copper wire, an iron core and magnet. The senso ...
Inner Rear View Mirror Power Source Circuit
DESCRIPTION
This circuit detects the state of the ignition switch, and sends it to the inner
rear view mirror assembly.
WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
Inspect the fuses for circuits related to this system before performing the followin ...