On-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT ENGINE OIL LEVEL
(a) Warm up the engine, stop it and wait 5 minutes. The engine oil level should be between the low level mark and full level mark on the engine oil level dipstick.
If the engine oil level is low, check for leaks and add engine oil to the full level mark.
NOTICE:
Do not fill the engine with oil to above the full level mark.
HINT:
A certain amount of engine oil will be consumed while driving. In the following situations, engine oil consumption may increase, and engine oil may need to be refilled in between oil maintenance intervals.
When judging the amount of oil consumption, keep in mind that the oil may have become diluted, making it difficult to judge the true level accurately.
2. INSPECT ENGINE OIL QUALITY
(a) Check the oil for deterioration, water contamination, discoloration or thinning. If the quality is visibly poor, replace the oil and filter.
3. INSPECT OIL PRESSURE
(a) Remove the oil pressure switch assembly (See page ).
(b) Install an oil pressure gauge. |
|
(c) Warm up the engine.
(d) Measure the oil pressure.
Standard Oil Pressure:
Condition |
Specified Condition |
---|---|
Idle |
30 kPa (0.3 kgf/cm2, 4.4 psi) or more |
4000 rpm |
260 kPa (2.7 kgf/cm2, 38 psi) or more |
(e) Remove the oil pressure gauge.
(f) Install the oil pressure switch assembly (See page ).
Removal
REMOVAL
CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the RH side and LH side.
The procedure listed below is for the LH side.
PROCEDURE
1. REMOVE REAR WHEEL
2. SEPARATE REAR SPEED SENSOR
(a) Remove the bolt and se ...
Power Back Door cannot be Opened or Closed Using the Power Back Door Switch
DESCRIPTION
When the power back door cannot be opened or closed using the power back door
control switch, one of the following may be malfunctioning: 1) power back door control
switch circuit, 2) power back door ECU (power back door motor unit) or 3) main ...
Diagnosis System
DIAGNOSIS SYSTEM
1. ECUS OR SENSORS WHICH COMMUNICATE THROUGH CAN COMMUNICATION SYSTEM
(a) CAN No. 1 Bus
(1) ECM
(2) Main body ECU (Driver side junction block)
(3) Combination meter
(4) Power steering ECU
(5) Air conditioning amplifier*3
(6) Center air ...