DESCRIPTION
DTC No. |
DTC Detection Condition |
Trouble Area |
---|---|---|
U0200 |
No communication from the outer mirror control ECU assembly (for driver side). |
|
WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
HINT:
PROCEDURE
1. |
RECONFIRM DTC OUTPUT |
(a) Reconfirm DTCs.
HINT:
If CAN MS bus DTC U1002 is output from the main body ECU (Techstream display: Main Body), troubleshoot for U1002 and check for malfunctions in the CAN MS bus circuit.
Result |
Proceed to |
---|---|
U1002 is not output from main body ECU (Techstream display: Main Body) |
A |
U1002 is output from main body ECU (Techstream display: Main Body) |
B |
B |
GO TO CIRCUITS INDICATED BY OUTPUT DTCS |
|
2. |
CHECK FOR OPEN IN CAN BUS WIRES (OUTER MIRROR CONTROL ECU ASSEMBLY BRANCH WIRE) |
(a) Turn the ignition switch off.
(b) Disconnect the outer mirror control ECU assembly (for driver side) connector. Text in Illustration
|
|
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection |
Condition |
Specified Condition |
---|---|---|
I13-9 (CANP) - I13-8 (CANN) |
Ignition switch off |
54 to 69 Ω |
NG |
REPAIR OR REPLACE CAN BUS BRANCH WIRE OR CONNECTOR (OUTER MIRROR CONTROL ECU ASSEMBLY BRANCH WIRE) |
|
3. |
CHECK HARNESS AND CONNECTOR (POWER SOURCE TERMINAL) |
(a) Measure the voltage according to the value(s) in the table below. Standard Voltage:
|
|
NG |
REPAIR OR REPLACE HARNESS OR CONNECTOR (POWER SOURCE CIRCUIT) |
|
4. |
CHECK HARNESS AND CONNECTOR (GROUND TERMINAL) |
(a) Measure the resistance according to the value(s) in the table below. Standard Resistance:
|
|
OK |
REPLACE OUTER MIRROR CONTROL ECU ASSEMBLY (FOR DRIVER SIDE) |
NG |
REPAIR OR REPLACE HARNESS OR CONNECTOR (GROUND CIRCUIT) |
Disassembly
DISASSEMBLY
PROCEDURE
1. REMOVE SEAT ADJUSTER COVER CAP RH
(a) Using a screwdriver wrapped with protective tape, disengage the 3
claws and remove the seat adjuster cover cap RH.
Text in Illustration
*1
...
Rear Spoiler
Components
COMPONENTS
ILLUSTRATION
Removal
REMOVAL
PROCEDURE
1. REMOVE UPPER BACK WINDOW PANEL TRIM
2. REMOVE REAR SPOILER ASSEMBLY
(a) Disconnect the connector.
(b) Remove the 2 hole ...
Vehicle Speed Sensor Malfunction (B2283)
DESCRIPTION
The skid control ECU converts wheel speed sensor signals into 4-pulse signals
and sends them to the combination meter. After this signal is converted into a more
precise rectangular waveform by the waveform shaping circuit inside the combinati ...