DESCRIPTION
DTC No. |
DTC Detection Condition |
Trouble Area |
---|---|---|
U0199 |
No communication from the outer mirror control ECU (for front passenger side) continues. |
|
WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
HINT:
PROCEDURE
1. |
RECONFIRM DTC OUTPUT |
(a) Reconfirm DTCs.
HINT:
If CAN MS bus DTC U1002 is output from the main body ECU (Techstream display: Main Body), troubleshoot for U1002 and check for malfunctions in the CAN MS bus circuit.
Result |
Proceed to |
---|---|
U1002 is not output from main body ECU (Techstream display: Main Body) |
A |
U1002 is output from main body ECU (Techstream display: Main Body) |
B |
B |
REPAIR CIRCUITS INDICATED BY OUTPUT DTCS |
|
2. |
CHECK FOR OPEN IN CAN BUS WIRES (OUTER MIRROR CONTROL ECU ASSEMBLY BRANCH WIRE) |
(a) Turn the ignition switch off.
(b) Disconnect the outer mirror control ECU assembly (for front passenger side) connector. Text in Illustration
|
|
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection |
Condition |
Specified Condition |
---|---|---|
H13-9 (CANP) - H13-8 (CANN) |
Ignition switch off |
54 to 69 Ω |
NG |
REPAIR OR REPLACE CAN BUS BRANCH WIRE OR CONNECTOR (OUTER MIRROR CONTROL ECU ASSEMBLY BRANCH WIRE) |
|
3. |
CHECK HARNESS AND CONNECTOR (POWER SOURCE TERMINAL) |
(a) Measure the voltage according to the value(s) in the table below. Standard Voltage:
|
|
NG |
REPAIR OR REPLACE HARNESS OR CONNECTOR (POWER SOURCE CIRCUIT) |
|
4. |
CHECK HARNESS AND CONNECTOR (GROUND TERMINAL) |
(a) Measure the resistance according to the value(s) in the table below. Standard Resistance:
|
|
OK |
REPLACE OUTER MIRROR CONTROL ECU ASSEMBLY (FOR FRONT PASSENGER SIDE) |
NG |
REPAIR OR REPLACE HARNESS OR CONNECTOR (GROUND CIRCUIT) |
Replacement
REPLACEMENT
PROCEDURE
1. REPLACE INTAKE VALVE GUIDE BUSH
(a) Heat the cylinder head to approximately 80 to 100°C (176 to 212°F).
(b) Place the cylinder head on wooden blocks.
(c) Using SST and a hammer, tap out the valve guide bush.
SST: 0 ...
Installation
INSTALLATION
PROCEDURE
1. INSTALL REAR NO. 3 SPEAKER ASSEMBLY
(a) Install the rear No. 3 speaker assembly with the 2 bolts.
(b) Engage the clamp.
2. INSTALL ROOF SIDE INNER GARNISH ASSEMBLY LH
...
How To Proceed With Troubleshooting
CAUTION / NOTICE / HINT
HINT:
Use the following procedure to troubleshoot the engine immobiliser system.
*: Using the Techstream.
PROCEDURE
1.
VEHICLE BROUGHT TO WORKSHOP
NEXT
...