Toyota Venza: Lost Communication with ECM / PCM "A" (U0100,U0129)

Toyota Venza Service Manual / Power Assist Systems / Power Steering System / Lost Communication with ECM / PCM "A" (U0100,U0129)

DESCRIPTION

The power steering ECU receives signals from the ECM and the brake actuator assembly (skid control ECU) via the CAN communication system.

DTC No.	DTC Detection Condition	Trouble Area
U0100	Lost communication with ECM/PCM "A"	CAN communication system ECM
U0129	Lost communication with brake system control module	CAN communication system Brake actuator assembly (Skid control ECU)

PROCEDURE

1.	CHECK FOR DTC (CAN COMMUNICATION SYSTEM)

(a) Clear the DTCs (See page ).

(b) Check for DTCs (See page ).

OK:

DTC is not output.

CHECK INTERMITTENT PROBLEMS

GO TO CAN COMMUNICATION SYSTEM

On-vehicle Inspection

ON-VEHICLE INSPECTION PROCEDURE 1. CHECK STEERING EFFORT (TORQUE) NOTICE: Some of these service operations may affect the SRS airbags. Read the precautionary notices concerning the SRS airbag sy ...

Assist Map Number Mismatch (C1582)

DESCRIPTION When an incorrect ECM or brake actuator assembly (skid control ECU) is installed after the assist map has been recorded in the power steering ECU, then DTC C1582 is stored because the ...

Other materials about Toyota Venza:

Basic Inspection
BASIC INSPECTION When the malfunction is not confirmed by the DTC check, troubleshooting should be carried out in all circuits considered to be possible causes of the problem. In many cases, by carrying out the basic engine check shown in the following pr ...

All Door Entry Lock/Unlock Functions do not Operate, but Wireless Functions Operate
DESCRIPTION When the wireless door lock and unlock functions operate, the communication circuit between the door lock receiver assembly and certification ECU (smart key ECU assembly) is normal. When the entry lock and unlock functions do not operate, radi ...

Inspection
INSPECTION PROCEDURE 1. INSPECT CYLINDER BLOCK FOR WARPAGE (a) Using a precision straightedge and feeler gauge, check the surface that is in contact with the cylinder head gasket for warpage. Maximum Warpage: 0.05 mm (0.00197 in.) I ...