DESCRIPTION
The power management control ECU receives shift position information from 2 sources. It receives a shift position P signal from the shift lock control unit assembly via a direct line, and shift position information from the ECM via CAN. If the information from these 2 sources is inconsistent, this DTC will be stored.
DTC No. |
DTC Detection Condition |
Trouble Area |
---|---|---|
U0100 |
Shift position information from ECM (via CAN) and shift lock control unit assembly (direct line) is inconsistent |
|
WIRING DIAGRAM
Refer to CAN communication system (See page ).
CAUTION / NOTICE / HINT
NOTICE:
When the power management control ECU is replaced with a new one and the cable from the negative (-) battery terminal is connected, the power source mode becomes the on (IG) mode. When the battery is removed and reinstalled, the power source mode that was selected when the battery was removed is restored.
PROCEDURE
1. |
REFER TO CAN COMMUNICATION SYSTEM |
See page
NEXT |
END |
IG Power Supply Voltage Malfunction (C1551)
DESCRIPTION
The power steering ECU distinguishes the ignition switch status as ON or off
through the IG power source circuit.
DTC No.
DTC Detection Condition
Trouble Area
C1551
IG power source ci ...
ACC Monitor Malfunction (B2274)
DESCRIPTION
This DTC is stored when there is a problem in the ACC output circuit. The ACC
circuit is the circuit that goes from inside the power management control ECU to
the ACC relay.
DTC No.
DTC Detection Condition
Tro ...
Installation
INSTALLATION
PROCEDURE
1. INSTALL REAR NO. 3 SPEAKER ASSEMBLY
(a) Install the rear No. 3 speaker assembly with the 2 bolts.
(b) Engage the clamp.
2. INSTALL ROOF SIDE INNER GARNISH ASSEMBLY LH
...