DESCRIPTION
The DTC is stored when the AFS ECU (headlight swivel ECU assembly) detects malfunctions in the LIN communication system.
DTC No. |
DTC Detection Condition |
Trouble Area |
---|---|---|
B2432 |
Malfunction in LIN communication system |
|
WIRING DIAGRAM
PROCEDURE
1. |
CHECK FOR DTC |
(a) Clear the DTCs (See page ).
(b) Check for DTCs (See page ).
OK:
DTC B2432 is not output.
OK |
USE SIMULATION METHOD TO CHECK |
|
2. |
CHECK HARNESS AND CONNECTOR (AFS ECU (HEADLIGHT SWIVEL ECU ASSEMBLY) - HEADLIGHT ASSEMBLY) |
(a) Disconnect the D44 AFS ECU (headlight swivel ECU assembly) connector.
(b) Disconnect the P12 inner rear view mirror assembly connector.
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection |
Condition |
Specified Condition |
---|---|---|
D44-10 (SMR) - P12-3 (LIN) |
Always |
Below 1 Ω |
P12-3 (LIN) - Body ground |
Always |
10 kΩ or higher |
NG |
REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
3. |
INSPECT AFS ECU (HEADLIGHT SWIVEL ECU ASSEMBLY) |
(a) Reconnect the D44 AFS ECU (headlight swivel ECU assembly) connector.
(b) Connect an oscilloscope to the P12 inner rear view mirror assembly connector. |
|
(c) Check the waveform. OK:
|
|
OK |
REPLACE INNER REAR VIEW MIRROR ASSEMBLY |
NG |
REPLACE AFS ECU (HEADLIGHT SWIVEL ECU ASSEMBLY) |
Installation
INSTALLATION
CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the RH side and LH side.
The procedure listed below is for the LH side.
PROCEDURE
1. INSTALL FRONT AIRBAG SENSOR
(a) Check that the ignition switch is off.
(b) Check ...
Disassembly
DISASSEMBLY
PROCEDURE
1. REMOVE SLIDING ROOF HOUSING CENTER FRAME
(a) Remove the 2 nuts and sliding roof housing center frame.
2. REMOVE NO. 4 SUNSHADE TRIM SUB-ASSEMBLY
(a) Remove the s ...
Removal
REMOVAL
PROCEDURE
1. REMOVE BRAKE BOOSTER ASSEMBLY
HINT:
Refer to the instructions for Removal of the brake booster assembly (See page
).
2. REMOVE HEADLIGHT LEVELING ECU ASSEMBLY (w/ HID Headlight System)
3. REMOVE STOP LIGHT SWITCH ASSEMBLY
4. ...