DESCRIPTION
The DTC is stored when the main body ECU (driver side junction block assembly) detects malfunctions in the LIN communication system.
DTC No. |
DTC Detection Condition |
Trouble Area |
---|---|---|
B124D |
Malfunction in LIN communication system |
|
WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
First perform the communication function inspections in How to Proceed with Troubleshooting to confirm that there are no CAN communication malfunctions before troubleshooting this symptom.
PROCEDURE
1. |
CHECK FOR DTC |
(a) Clear the DTCs (See page ).
(b) Check for DTCs (See page ).
OK:
DTC B124D is not output.
OK |
USE SIMULATION METHOD TO CHECK |
|
2. |
CHECK HARNESS AND CONNECTOR (AFS ECU - INNER REAR VIEW MIRROR ASSEMBLY) |
(a) Disconnect the D44 AFS ECU (headlight swivel ECU assembly) connector.
(b) Disconnect the P12 inner rear view mirror assembly connector.
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection |
Condition |
Specified Condition |
---|---|---|
D44-10 (SMR) - P12-3 (LIN) |
Always |
Below 1 Ω |
P12-3 (LIN) - Body ground |
Always |
10 kΩ or higher |
NG |
REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
3. |
INSPECT AFS ECU (HEADLIGHT SWIVEL ECU ASSEMBLY) |
(a) Reconnect the D44 AFS ECU (headlight swivel ECU assembly) connector.
(b) Connect an oscilloscope to the P12 inner rear view mirror assembly connector. |
|
(c) Check the waveform. OK:
|
|
OK |
REPLACE INNER REAR VIEW MIRROR ASSEMBLY |
NG |
REPLACE AFS ECU (HEADLIGHT SWIVEL ECU ASSEMBLY) |
Trailer towing tips
Your vehicle will handle differently when towing a trailer. Help to avoid an
accident, death or serious injury, keep the following in mind when towing:
• Speed limits for towing a trailer vary by state or province. Do not exceed
the posted towing speed ...
Theft Deterrent System Communication Line High Fixation (B279A)
DESCRIPTION
If the communication line (EFIO-IMI) to the transponder key ECU assembly is stuck
high output (e.g. shorted to +B), the ECM stores this DTC.
DTC No.
DTC Detection Condition
Trouble Area
B279A
...
Operation Check
OPERATION CHECK
1. CHECK BASIC FUNCTIONS
(a) When the back door is partially closed, check that the motor operates to
fully close (lock) the back door.
(b) Check that the back door can be opened.
(c) When the back door is partially closed and then the mo ...