Toyota Venza: Lost Communication with AFS LIN (B124D)

Toyota Venza Service Manual / Networking / Lin Communication System / Lost Communication with AFS LIN (B124D)

DESCRIPTION

Refer to DTC B124D (Lighting system) (See page ).

DTC No.	DTC Detection Condition	Trouble Area
B124D	Malfunctions in LIN communication system	Inner rear view mirror assembly Harness or connector AFS ECU (headlight swivel ECU assembly)

WIRING DIAGRAM

Refer to DTC B124D (Lighting system) (See page ).

PROCEDURE

1.	REFER TO DTC B124D (Lighting system)

See page

END

LIN Communication Master Malfunction (B2287)

DESCRIPTION This DTC is stored when there is an open, short or ECU communication malfunction between the power management control ECU and certification ECU (smart key ECU assembly). DTC ...

P/W Master Switch Communication Stop (B1206)

DESCRIPTION This DTC is stored when LIN communication between the multiplex network master switch assembly and main body ECU (driver side junction block assembly) stops for more than 10 seconds. ...

Other materials about Toyota Venza:

Installation
INSTALLATION PROCEDURE 1. INSTALL POWER SEAT SWITCH (a) Install the power seat switch with the 3 screws. (b) Connect the connector. 2. INSTALL FRONT SEAT CUSHION SHIELD ASSEMBLY 3. INSTALL SLID ...

Terminals Of Ecu
TERMINALS OF ECU 1. REAR TELEVISION CAMERA ASSEMBLY (a) Disconnect the R21 rear television camera assembly connector. (b) Measure the voltage on the wire harness side connector according to the value(s) in the table below. Terminal No. (Symb ...

Precaution
PRECAUTION NOTICE: When disconnecting the cable from the negative (-) battery terminal, initialize the following systems after the cable is reconnected. System Name See Procedure Back Door Closer System ...