DESCRIPTION
DTC No. |
DTC Detection Condition |
Trouble Area |
---|---|---|
U0164 |
No communication from the air conditioning amplifier continues. |
|
WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
HINT:
PROCEDURE
1. |
RECONFIRM DTC OUTPUT |
(a) Reconfirm DTCs.
HINT:
If power management bus DTC U1002 is output from the power management control ECU (Techstream display: PM2 Gateway), troubleshoot for U1002 and check for malfunctions in the power management main bus circuit.
Result |
Proceed to |
---|---|
U1002 is not output from power management control ECU (Techstream display: PM2 Gateway) |
A |
U1002 is output from power management control ECU (Techstream display: PM2 Gateway) |
B |
B |
GO TO CIRCUITS INDICATED BY OUTPUT DTCS |
|
2. |
CHECK FOR OPEN IN CAN BUS WIRES (AIR CONDITIONING AMPLIFIER BRANCH WIRE) |
(a) Turn the ignition switch off.
(b) Disconnect the air conditioning amplifier connector. Text in Illustration
|
|
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection |
Condition |
Specified Condition |
---|---|---|
D47-11 (CANH) - D47-12 (CANL) |
Ignition switch off |
54 to 69 Ω |
NG |
REPAIR OR REPLACE CAN BUS BRANCH WIRE OR CONNECTOR (AIR CONDITIONING AMPLIFIER BRANCH WIRE) |
|
3. |
CHECK HARNESS AND CONNECTOR (POWER SOURCE TERMINAL) |
(a) Turn the ignition switch to ON.
(b) Measure the voltage according to the value(s) in the table below. Standard Voltage:
|
|
NG |
REPAIR OR REPLACE HARNESS OR CONNECTOR (POWER SOURCE CIRCUIT) |
|
4. |
CHECK HARNESS AND CONNECTOR (GROUND TERMINAL) |
(a) Measure the resistance according to the value(s) in the table below. Standard Resistance:
|
|
OK |
REPLACE AIR CONDITIONING AMPLIFIER |
NG |
REPAIR OR REPLACE HARNESS OR CONNECTOR (GROUND CIRCUIT) |
System Description
SYSTEM DESCRIPTION
1. ACCESSORY METER ASSEMBLY
(a) Warning or Indicator
Item
Detail
Front passenger side seat belt warning light
Receives a front passenger side seat belt warning light signal from the
co ...
Front Occupant Classification Sensor RH Collision Detection (B1786)
DESCRIPTION
DTC B1786 is output when the occupant classification ECU receives a collision
detection signal sent by the front occupant classification sensor RH if an accident
occurs.
DTC B1786 is also output when the front seat assembly RH is subjected to ...
Removal
REMOVAL
PROCEDURE
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable
is reconnected (See page ).
2. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY
3. REMOVE COOL AIR ...