Toyota Venza: Lin Communication System
- Precaution
- Parts Location
- System Description
- System Diagram
- How To Proceed With Troubleshooting
- Problem Symptoms Table
- Terminals Of Ecu
- Diagnosis System
- Dtc Check / Clear
- Data List / Active Test
- Lost Communication with Power Source Control (B278C)
- Diagnostic Trouble Code Chart
- No Response from Steering Lock ECU (B2786)
- Lost Communication with Automatic High Beam Sensor (B2432)
- Communication Malfunction between ECUs Connected by LIN (B2785)
- Rear Door LH ECU Communication Stop (B2324)
- LIN Communication Bus Malfunction (B2325)
- Front Passenger Side Door ECU Communication Stop (B2322)
- Rear Door RH ECU Communication Stop (B2323)
- Driver Side Door ECU Communication Stop (B2321)
- Sliding Roof ECU Communication Stop (B1273)
- LIN Communication Master Malfunction (B2287)
- Lost Communication with AFS LIN (B124D)
- P/W Master Switch Communication Stop (B1206)
Open in One Side of CAN Branch Line
DESCRIPTION
If some ECUs and sensors are not displayed on the "CAN Bus Check" screen of the
Techstream and some ECUs and sensors repeatedly appear and disappear from the screen
when the ...
Precaution
PRECAUTION
NOTICE:
When disconnecting the cable from the negative (-) battery terminal, initialize
the following systems after the cable is reconnected.
System Name
See Proc ...
Other materials about Toyota Venza:
Gauges and meters
►Vehicles with smart key system
The following gauges, meters and display illuminate when the “ENGINE START STOP”
switch is in IGNITION ON mode.
►Vehicles without smart key system
The following gauges, meters and displays illuminate when ...
Remote Up / Down Function does not Operate
DESCRIPTION
When the ignition switch is ON, the power window regulator master switch assembly
sends remote up/down signals to each power window regulator motor assembly via the
LIN communication line.
WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
T ...
Inspection
INSPECTION
PROCEDURE
1. INSPECT REAR SPEAKER ASSEMBLY
(a) With the speaker installed, check that there is no looseness or other abnormalities.
(b) Check that there is no foreign matter in the speaker, no tears on the speaker
cone or other abnormalities.
...
0.1682