Toyota Venza: Lighting System
- Parts Location
- Precaution
- System Description
- System Diagram
- How To Proceed With Troubleshooting
- Operation Check
- Customize Parameters
- Initialization
- Problem Symptoms Table
- Terminals Of Ecu
- Diagnosis System
- Dtc Check / Clear
- Fail-safe Chart
- Freeze Frame Data
- Data List / Active Test
- Diagnostic Trouble Code Chart
- Vehicle Specifications have not been Stored (B2451)
- Lost Communication with Automatic High Beam Sensor (B2432)
- Initialization has not been Performed (B2450)
- HL AutoLeveling ECU Failure (B2420)
- Rear Height Control Sensor (B241A)
- Height Control Sensor Malfunction (B2416)
- Vehicle Speed Sensor Malfunction (B2415)
- Height Control Sensor Data Out of Range When Initializing (B2452)
- Variation Error (B2453)
- Light Sensor Circuit Malfunction (B1244)
- Lost Communication with ECM (U0101,U0073,U0126,U0129,U0142,U0182,U1000)
- Automatic High Beam Mirror (B124A)
- Automatic High Beam System (B124B)
- Automatic High Beam Camera (B124C)
- Lost Communication with AFS LIN (B124D)
- Steering Position Sensor Malfunction (B2414)
- Headlight Relay Circuit
- Headlight Solenoid Circuit
- Daytime Running Light Relay Circuit
- Headlight (HI-BEAM) Circuit
- Front Fog Light Circuit
- Headlight Signal Circuit
- Light Control Switch Circuit
- Door Mirror Foot Light Circuit
- Parking Brake Switch Circuit
- Taillight Relay Circuit
- Headlight Beam Level Control Actuator Circuit
- Headlight Leveling ECU Power Source Circuit
- Indicator Circuit
- Speed Signal Circuit
- Inner Rear View Mirror Power Source Circuit
- LVL Terminal Circuit
- Diagnosis Circuit
License Plate Light Assembly
Components
COMPONENTS
ILLUSTRATION
ILLUSTRATION
Installation
INSTALLATION
PROCEDURE
1. INSTALL LICENSE PLATE LIGHT ASSEMBLY
(a) Engage the 2 claws to install the license pla ...
Parts Location
PARTS LOCATION
ILLUSTRATION
ILLUSTRATION
ILLUSTRATION
ILLUSTRATION
...
Other materials about Toyota Venza:
Torque Sensor Zero Point Adjustment Incomplete (C1516,C1526)
DESCRIPTION
These DTCs do not indicate a malfunction. The power steering ECU stores these
DTCs when it determines that the rotation angle sensor value initialization and
torque sensor zero point calibration are incomplete.
DTC No.
D ...
Inspection
INSPECTION
PROCEDURE
1. INSPECT THROTTLE BODY ASSEMBLY
Text in Illustration
*1
Component without harness connected
(Throttle Body)
(a) Check that the throttle valve opens and closes smoothly.
(b) Check that there is no ...
Hydraulic Test
HYDRAULIC TEST
1. PERFORM HYDRAULIC TEST
(a) Measure the line pressure.
CAUTION:
The line pressure test should always be carried out with at least 2 people. One
person should observe the condition of wheels and wheel chocks while the other is
perform ...
1.898