Toyota Venza manuals

Toyota Venza: Key battery

Replace the battery with a new one if it is discharged.

 - You will need the following items:

• Flathead screwdriver (To prevent damage to the key, cover the tip of the screwdriver with rag.)
• Small Phillips-head screwdriver • Lithium battery

Vehicles with smart key system: CR1632 Vehicles without smart key system: CR2025

 - Replacing the battery (vehicles with smart key system)


Take out the mechanical key.


Remove the cover.


Remove the depleted battery.

Insert a new battery with the “+” terminal facing up.

 - Replacing the battery (vehicles without smart key system)


Remove the cover.


Remove the module.


Open the case cover using a flathead screwdriver protected with tape etc. and remove the depleted battery.

Insert a new battery with the “+” terminal facing up.

 - If the electronic key battery is discharged

The following symptoms may occur.

• The smart key system and wireless remote control will not function properly.

• The operational range is reduced.

- Use a CR1632 (vehicles with smart key system), or CR2025 (vehicles without smart key system) lithium battery

• Batteries can be purchased at your Toyota dealer, jewelers, or camera stores.

• Replace only with the same or equivalent type recommended by a Toyota dealer.

• Dispose of used batteries according to the local laws.

CAUTION

 - Removed battery and other parts

These parts are small and if swallowed by a child they can cause choking.

Keep away from children. Failure to do so could result in death or serious injury.

NOTICE
 - For normal operation after replacing the battery

Observe the following precautions to prevent accidents.

• Always work with dry hands.

Moisture may cause the battery to rust.

• Do not touch or move any other components inside the electronic key.

• Do not bend the battery terminals.

Air conditioning filter
The air conditioning filter must be changed regularly to maintain air conditioning efficiency.  - Removal method Vehicles with smart key system: Turn the “ENGINE START STOP” switch off. ...

Checking and replacing fuses
If any of the electrical components do not operate, a fuse may have blown. If this happens, check and replace the fuses as necessary. Vehicles with smart key system: Turn the “ENGINE START STOP ...

Other materials about Toyota Venza:

Power Source Mode does not Change to ON (ACC)
DESCRIPTION When the engine switch is pushed with the electrical key in the cabin, the power management control ECU receives signals to change the power source mode. HINT: To allow use of the Techstream to inspect the push-button start function when the ...

Lost Communication with AFS LIN (B124D)
DESCRIPTION Refer to DTC B124D (Lighting system) (See page ). DTC No. DTC Detection Condition Trouble Area B124D Malfunctions in LIN communication system Inner rear view mir ...

Disposal
DISPOSAL CAUTION / NOTICE / HINT CAUTION: Before performing pre-disposal deployment of any SRS component, review and closely follow all applicable environmental and hazardous material regulations. Pre-disposal deployment may be considered hazardous mate ...

© 2016-2024 Copyright www.tovenza.com

0.1443