DESCRIPTION
This symptom may occur for any of the windows.
The jam protection function operates within a specified range during the manual up or auto up operation.
CAUTION / NOTICE / HINT
NOTICE:
PROCEDURE
1. |
PERFORM INITIALIZATION (APPLICABLE LOCATION) |
(a) Initialize the power window regulator motor assembly (applicable location) (See page ).
|
2. |
CHECK POWER WINDOW CONTROL SYSTEM (AUTO UP/DOWN FUNCTION) |
(a) Check if the power window auto up/down function operates normally (See page ).
OK:
Auto up/down function is normal.
NG |
GO TO OTHER PROBLEM (Proceed to Problem Symptoms Table) |
|
3. |
CHECK JAM PROTECTION FUNCTION OPERATING RANGE |
(a) Check if the jam protection function operates normally for the applicable power window.
HINT:
The jam protection function will not operate within 4 mm (0.157 in.) of the fully closed position.
OK:
Jam protection function operates normally.
Result |
Proceed to |
---|---|
OK |
A |
NG (Driver side power window) |
B |
NG (Front passenger side power window) |
C |
NG (Rear LH side power window) |
D |
NG (Rear RH side power window) |
E |
A |
END (PROBLEM DUE TO INITIALIZATION FAILURE) |
B |
REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY (for Driver Side) |
C |
REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY (for Front Passenger Side) |
D |
REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY (for Rear LH Side) |
E |
REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY (for Rear RH Side) |
Adjustment
ADJUSTMENT
CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
Centering bolts are used to mount the door hinge to the vehicle body
and door. The door cannot b ...
Panel Switches do not Function
PROCEDURE
1.
CHECK PANEL SWITCH
(a) Check for foreign matter around the switches that might prevent operation.
OK:
No foreign matter is found.
NG
REMOVE ANY FOREIGN MATTER FOUND
...
Cruise Control Main Switch
Components
COMPONENTS
ILLUSTRATION
Removal
REMOVAL
PROCEDURE
1. REMOVE STEERING PAD
(See page )
2. REMOVE CRUISE CONTROL MAIN SWITCH
(a) Remove the 2 screws.
(b) Disconnect t ...