DESCRIPTION
The TCM monitors its internal operation and it will set this DTC when it detects an internal malfunction.
DTC No. |
DTC Detection Condition |
Trouble Area |
---|---|---|
P062F |
TCM internal error (EEPROM) |
TCM |
MONITOR DESCRIPTION
The TCM monitors its internal operation. If the internal operation is malfunctioning, the TCM illuminates the MIL and sets a DTC.
MONITOR STRATEGY
Related DTCs |
P062F: Internal control module EEPROM error |
Required sensors/Components (Main) |
TCM |
Required sensors/Components (Related) |
- |
Frequency of operation |
Once per driving cycle |
Duration |
3 times |
MIL operation |
Immediate |
Sequence of operation |
None |
TYPICAL ENABLING CONDITIONS
Monitor runs whenever following DTCs not present |
None |
Time after engine start |
10 seconds or more |
Battery voltage |
8 V or higher |
Ignition switch |
ON |
Starter |
OFF |
TYPICAL MALFUNCTION THRESHOLDS
Permanent fault code data |
Mismatch (3 times or more) |
CAUTION / NOTICE / HINT
NOTICE:
PROCEDURE
1. |
READ OUTPUT DTC (DTC P062F) |
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON.
(c) Turn the Techstream on.
(d) Clear DTCs (See page ).
(e) Turn the ignition switch off and turn the Techstream off.
(f) Disconnect the Techstream.
(g) Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.
(h) Connect the cable to the negative (-) battery terminal.
(i) Connect the Techstream to the DLC3.
(j) Turn the ignition switch to ON.
(k) Turn the Techstream on.
(l) Select the following menu items: Powertrain / ECT / Trouble Codes.
(m) Read DTCs.
Result
Result |
Proceed to |
---|---|
No output |
A |
P062F |
B |
A |
CHECK FOR INTERMITTENT PROBLEMS |
B |
REPLACE TCM |
Camshaft Position "B" - Timing Over-Advanced or System Performance (Bank 1)
(P0014,P0015)
DESCRIPTION
Refer to DTC P0013 (See page ).
DTC No.
DTC Detection Condition
Trouble Area
P0014
The valve timing is stuck at a certain value when in the advance range
(2 trip detection logic).
...
ABS Warning Light does not Come ON
DESCRIPTION
The skid control ECU is connected to the combination meter via CAN communication.
WIRING DIAGRAM
Refer to ABS Warning Light Remains ON (See page
).
PROCEDURE
1.
CHECK CAN COMMUNICATION SYSTEM
(a) Check if a C ...
Internal Control Module EEPROM Error (P062F)
DESCRIPTION
The ECM monitors its internal operation and it stores this DTC when it detects
an internal malfunction.
DTC No.
DTC Detection Condition
Trouble Area
P062F
An ECM internal error (EEPRO ...