Toyota Venza: Interior Panels / Trim

Solar Sensor

Components COMPONENTS ILLUSTRATION On-vehicle Inspection ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT SOLAR SENSOR (a) Disconnect the solar sensor connector. ...

Front Console Box

...

Other materials about Toyota Venza:

Removal
REMOVAL CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH side and LH side. The procedure listed below is for the LH side. PROCEDURE 1. REMOVE REAR WHEEL 2. SEPARATE REAR SPEED SENSOR 3. REMOVE REAR AXLE SHAFT NUT ...

No Signal from Transmitter ID1 (C2121/21-C2124/24,C2181/81-C2184/84)
DESCRIPTION The tire pressure warning valve and transmitter installed in each tire and wheel assembly measures the tire pressures. The measured values are transmitted as radio waves to the tire pressure warning antenna and receiver on the body and then se ...

Installation
INSTALLATION PROCEDURE 1. ADJUST COMPRESSOR OIL LEVEL (a) When replacing the cooler compressor assembly with a new one, gradually discharge the inert gas (helium) from the service valve, and drain the following amount of oil from the vent ...