Toyota Venza: Interior Light Auto Cut Circuit

Toyota Venza Service Manual / Lighting (int) / Lighting System / Interior Light Auto Cut Circuit

DESCRIPTION

When battery saving control operates while the interior lights are on, the main body ECU (driver side junction block assembly) opens the DOME CUT relay to turn off the lights.

WIRING DIAGRAM

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following inspection procedure.

PROCEDURE

1.	INSPECT DOME CUT RELAY

(a) Remove the DOME CUT relay.

(b) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection	Condition	Specified Condition
3 - 5	Battery voltage applied to terminals 1 and 2	Below 1 Ω
3 - 5	Battery voltage not applied between terminals	10 kΩ or higher

Text in Illustration

*1	Component without harness connected (DOME CUT Relay)

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

REPLACE DOME CUT RELAY

Interior Light Circuit

DESCRIPTION The illuminated entry system controls the roof console box assembly, step or spot light assembly and transponder key amplifier*1. HINT: *1: w/o Smart Key System WIRING DIAGRAM PRO ...

Engine Switch Illumination Circuit

DESCRIPTION The illuminated entry system controls the engine switch illumination. WIRING DIAGRAM PROCEDURE 1. PERFORM ACTIVE TEST USING TECHSTREAM (a) Connect th ...

Other materials about Toyota Venza:

Short in Driver Side Squib Circuit (B1800/51-B1803/51)
DESCRIPTION The driver side squib circuit consists of the center airbag sensor assembly, spiral cable and steering pad. The center airbag sensor assembly uses this circuit to deploy the airbag when deployment conditions are met. These DTCs are stored wh ...

Fail-safe Chart
FAIL-SAFE CHART 1. FAIL SAFE FUNCTION (a) The following chart shows the status of the controls when the system is normal and malfunctioning. The passenger airbag ON/OFF indicator ("ON" and "OFF") comes on for approximately 4 ...

Voice is not Recognized
PROCEDURE 1. CHECK CONDITION (a) Check if the system voice recognition level is low when recognizing a particular voice. Result Proceed to System voice recognition level is low only fo ...