INSTALLATION
PROCEDURE
1. INSTALL ECM
(a) Install the bracket to the ECM with the 5 screws. |
|
(b) Install the ECM with the 3 bolts. Torque: 8.0 N·m {82 kgf·cm, 71 in·lbf} |
|
(c) Connect the 2 ECM connectors and lower the 2 levers. NOTICE:
|
|
(d) Install the 3 wire harness clamps. |
|
2. INSTALL AIR CLEANER BRACKET
(a) Install the air cleaner bracket with the 2 bolts. Torque: 7.8 N·m {80 kgf·cm, 69 in·lbf} |
|
3. INSTALL AIR CLEANER CASE SUB-ASSEMBLY
4. INSTALL AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY
5. INSTALL AIR CLEANER CAP SUB-ASSEMBLY
6. INSTALL NO. 1 VACUUM SWITCHING VALVE ASSEMBLY
7. INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY
8. INSTALL OUTER COWL TOP PANEL SUB-ASSEMBLY
9. INSTALL WINDSHIELD WIPER MOTOR AND LINK
(a) Install the windshield wiper motor and link (See page ).
10. INSTALL COOL AIR INTAKE DUCT SEAL
11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
CAUTION:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).
12. PERFORM REGISTRATION
(a) The Vehicle Identification Number (VIN) must be input into a replacement ECM (See page ).
Precaution
PRECAUTION
1. NOTICE FOR INITIALIZATION:
NOTICE:
When disconnecting the cable from the negative (-) battery terminal, initialize
the following systems after the cable is reconnected.
System Name
See Procedure
Back D ...
Satellite Radio Antenna
Components
COMPONENTS
ILLUSTRATION
ILLUSTRATION
Removal
REMOVAL
PROCEDURE
1. REMOVE ROOF HEADLINING ASSEMBLY
(See page )
2. REMOVE ROOF ANTENNA POLE SUB-ASSEMBLY
3. REMOVE SATELLITE RADIO ANTENNA ASSEMBLY
(a) Disconnect the co ...
Precaution
PRECAUTION
1. PRECAUTION FOR DISCONNECTING BATTERY CABLE
NOTICE:
When disconnecting the cable from the negative (-) battery terminal, initialize
the following systems after the cable is reconnected.
System
See Procedure
...