INSTALLATION
PROCEDURE
1. INSTALL CHARCOAL CANISTER LEAK DETECTION PUMP SUB-ASSEMBLY
(a) Engage the 2 claws to install a new charcoal canister leak detection pump sub-assembly to the charcoal canister assembly. NOTICE:
|
|
2. INSTALL CHARCOAL CANISTER ASSEMBLY
(a) Connect the 2 clips to install the charcoal canister assembly.
(b) Install the 4 nuts.
Torque:
5.5 N·m {56 kgf·cm, 49 in·lbf}
(c) Connect the air line tube to the charcoal canister leak detection pump sub-assembly.
NOTICE:
(d) Connect the purge line hose to the charcoal canister assembly.
(e) Connect the connector to the charcoal canister leak detection pump sub-assembly.
(f) Push in the tube connector to the pipe and push up the retainer to connect the vent line tube.
Text in Illustration
*1 |
Retainer |
Push Up |
NOTICE:
3. INSTALL NO. 1 FLOOR UNDER COVER
(a) Install the No. 1 floor under cover with the 4 nuts and clip. Torque: Nut A : 2.2 N·m {22 kgf·cm, 19 in·lbf} HINT: The 4 nuts and clip are attached to the No. 1 floor under cover. |
|
On-vehicle Inspection
ON-VEHICLE INSPECTION
CAUTION / NOTICE / HINT
CAUTION:
Be sure to correctly follow the removal and installation procedures for the front
passenger airbag assembly.
PROCEDURE
1. INSPECT FRONT PASSENGER AIRBAG ASSEMBLY (Vehicle not Involved in Collision)
...
Installation
INSTALLATION
PROCEDURE
1. INSTALL FUEL PRESSURE REGULATOR ASSEMBLY
(a) Apply a light coat of gasoline to 2 new O-rings, and install them
onto the fuel pressure regulator.
Text in Illustration
*1
New O-r ...
CD cannot be Ejected
PROCEDURE
1.
CHECK OPERATION
(a) Press the CD eject switch of the navigation receiver assembly for 10 seconds
or more and check that the CD is ejected.
OK:
CD is ejected.
NG
REPLACE NAVIGATION RECEIVER ...