INSTALLATION
PROCEDURE
1. INSTALL TRANSMISSION CONTROL CABLE ASSEMBLY
NOTICE:
Before installing the transmission control cable assembly, check that the park/neutral position switch and the shift lever are in neutral.
(a) Pass the control cable from the cabin to the engine compartment.
(b) Install the No. 2 shift cable grommet retainer with the 2 bolts. Text in Illustration
Torque: 5.0 N·m {51 kgf·cm, 44 in·lbf} |
|
(c) Connect the transmission control cable to the No. 2 transmission control cable bracket.
(d) Before attaching cable to transmission, make sure to pull cable through dash grommet into engine compartment side until cable crimp is fully seated against dash grommet.
(e) Connect the transmission control cable to the transmission control shaft lever with the nut. Torque: 13 N·m {130 kgf·cm, 9 ft·lbf} |
|
(f) Connect the transmission control cable to the transmission control cable bracket with a new clip.
2. INSTALL FRONT NO. 1 FLOOR HEAT INSULATOR
(a) Install the front No. 1 floor heat insulator to the body with the 3 nuts. Torque: 4.9 N·m {50 kgf·cm, 43 in·lbf} |
|
3. INSTALL EXHAUST MANIFOLD TO HEAD GASKET
4. INSTALL EXHAUST MANIFOLD SUB-ASSEMBLY RH
5. INSTALL MANIFOLD STAY
6. INSTALL FRONT NO. 3 EXHAUST PIPE SUB-ASSEMBLY
7. INSTALL AIR CLEANER CASE
8. INSTALL AIR CLEANER CAP WITH HOSE
9. INSTALL INLET NO. 2 AIR CLEANER
10. INSTALL COOL AIR INTAKE DUCT SEAL
11. INSTALL INSTRUMENT PANEL REINFORCEMENT ASSEMBLY WITH AIR CONDITIONING UNIT
(See page )
12. INSPECT SHIFT LEVER POSITION
13. ADJUST SHIFT LEVER POSITION
14. INSPECT FOR EXHAUST GAS LEAK
Removal
REMOVAL
PROCEDURE
1. DISCHARGE FUEL SYSTEM PRESSURE
HINT:
(See page ).
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable
is reconnected (See page ).
3. REMOV ...
Disposal
DISPOSAL
CAUTION / NOTICE / HINT
HINT:
The tire pressure warning valve and transmitter is powered by a lithium battery.
When disposing of the tire pressure warning valve and transmitter, remove the battery
and dispose of it correctly.
PROCEDURE
1. DIS ...
System Description
SYSTEM DESCRIPTION
1. FRONT POWER SEAT CONTROL SYSTEM DESCRIPTION
The driver seat is equipped with slide, reclining, lifter, front vertical and
lumbar support adjustment functions.
2. FUNCTION OF MAIN COMPONENTS
The following functions are available:
...