INSTALLATION
PROCEDURE
1. INSTALL SHIFT LEVER ASSEMBLY
NOTICE:
Check that the park/neutral position switch and the shift lever are in neutral.
(a) Slide the slider of the transmission control cable in the direction indicated by the arrow and pull the lock piece outward. Text in Illustration
|
|
(b) Turn the lock nut of the transmission control cable counterclockwise. While holding the lock nut, push in the stopper. Text in Illustration
|
|
(c) Connect the outer part of the transmission control cable to the shift lever retainer. Text in Illustration
NOTICE: The lock nut is fully seated against the shift lever retainer. |
|
(d) Install the transmission control cable end to the shift lever assembly. Text in Illustration
NOTICE:
|
|
(e) Install the shift lever assembly with the 4 nuts. Torque: 12 N·m {122 kgf·cm, 9 ft·lbf} |
|
(f) Connect the 2 connectors.
(g) Push the lock piece into the adjuster case. Text in Illustration
NOTICE: Securely push in the lock piece until the slider lock is engaged. |
|
2. INSTALL CONSOLE BOX SUB-ASSEMBLY
3. INSTALL POSITION INDICATOR HOUSING ASSEMBLY
4. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY
5. INSTALL LOWER INSTRUMENT PANEL SUB-ASSEMBLY
6. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
7. INSTALL COWL SIDE TRIM SUB-ASSEMBLY RH
8. INSTALL FRONT DOOR SCUFF PLATE RH
9. INSTALL LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL
10. INSTALL COWL SIDE TRIM SUB-ASSEMBLY LH
11. INSTALL FRONT DOOR SCUFF PLATE LH
12. INSTALL AIR CONDITIONING CONTROL ASSEMBLY
13. INSTALL CONSOLE BOX ASSEMBLY
14. INSTALL NO. 2 CONSOLE BOX CARPET
15. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY (w/o Seat Heater System)
16. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY (w/ Seat Heater System)
17. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).
18. INSPECT SHIFT LEVER POSITION
19. ADJUST SHIFT LEVER POSITION
Open in Inside Luggage Compartment Electrical Key Oscillator Circuit (B27A7)
DESCRIPTION
The certification ECU (smart key ECU assembly) generates a request signal and
sends it to the indoor electrical key oscillator (for rear floor). To detect the
key inside the cabin, the indoor electrical key oscillator (for rear floor) creates ...
Navigation Receiver Assembly Communication Stop Mode
DESCRIPTION
Detection Item
Symptom
Trouble Area
Navigation Receiver Assembly Communication Stop Mode
"Display and Navigation (AVN1)" is not displayed on the "CAN
Bus ...
Reassembly
REASSEMBLY
PROCEDURE
1. INSTALL NO. 1 SUNSHADE TRIM SUB-ASSEMBLY
(a) Slide and install the No. 1 sunshade trim sub-assembly.
2. INSTALL NO. 2 SUNSHADE TRIM SUB-ASSEMBLY
(a) Slide and ins ...