Toyota Venza: Installation

Toyota Venza Service Manual / U660e Automatic Transmission / Transaxle / Park / Neutral Position Switch / Installation

INSTALLATION

PROCEDURE

1. INSTALL PARK/NEUTRAL POSITION SWITCH ASSEMBLY

(a) Move the shift lever to N.

(b) Align the protrusions of the park/neutral position switch.

Text in Illustration

*1	Protrusion

Torque:

5.4 N·m {55 kgf·cm, 48 in·lbf}

NOTICE:

Before installing the park/neutral position switch, remove any dirt or rust on the installation portion of the control shaft. Be sure to install the switch straight along the shaft while being careful not to deform the plate spring that supports the shaft. If the plate spring is deformed, the park/neutral position switch cannot be reinstalled correctly.
After installing the park/neutral position switch, confirm that the 2 protrusions on the switch are aligned.

(d) Install the transmission control shaft lever to the control shaft with the nut and washer.

Torque:

13 N·m {130 kgf·cm, 9 ft·lbf}

(e) Connect the connector to the park/neutral position switch.

(f) Connect the transmission control cable to the transmission control cable bracket with a new clip.

(g) Connect the transmission control cable to the transmission control shaft lever with the nut.

Torque:

13 N·m {130 kgf·cm, 9 ft·lbf}

2. INSTALL AIR CLEANER BRACKET

(a) Install the air cleaner bracket with the 3 bolts.

Torque:

7.8 N·m {80 kgf·cm, 69 in·lbf}

(b) Install the wire harness clamp.

3. INSTALL AIR CLEANER CASE

4. INSTALL AIR CLEANER CAP WITH HOSE

5. INSTALL INLET NO. 2 AIR CLEANER

6. INSTALL COOL AIR INTAKE DUCT SEAL

7. INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY OPERATION

8. INSPECT SHIFT LEVER POSITION

9. ADJUST SHIFT LEVER POSITION

Adjustment

ADJUSTMENT PROCEDURE 1. ADJUST PARK/NEUTRAL POSITION SWITCH ASSEMBLY (a) Remove the transmission control shaft lever. HINT: See the steps from "Remove Cool Air Intake Duct Seal" through ...

Other materials about Toyota Venza:

Engine immobilizer system
The vehicle’s keys have built-in transponder chips that prevent the engine from starting if the key has not been previously registered in the vehicle’s on-board computer. Never leave the keys inside the vehicle when you leave the vehicle. Vehicles ...

Fail-safe Chart
FAIL-SAFE CHART If a problem occurs in the power steering system, the power steering assist will be stopped or the amount of power assist will be decreased to protect the system. Power Steering System Malfunction Fail-safe Operation ...

Center Power Outlet Socket
Components COMPONENTS ILLUSTRATION Installation INSTALLATION PROCEDURE 1. INSTALL CENTER POWER OUTLET SOCKET COVER (a) Engage the 2 claws to install the center power outlet socket cover. 2 ...

Toyota Venza: Installation

Adjustment

Shift Lever

Other materials about Toyota Venza: