INSTALLATION
PROCEDURE
1. INSTALL TRANSFER ASSEMBLY
(a) Install the transfer assembly to the automatic transaxle assembly with 2 new bolts and the 6 nuts. Torque: 69 N·m {700 kgf·cm, 51 ft·lbf} NOTICE:
|
|
2. INSTALL AUTOMATIC TRANSAXLE ASSEMBLY (for 2GR-FE)
See page
3. INSTALL AUTOMATIC TRANSAXLE ASSEMBLY (for 1AR-FE)
See page
Data List / Active Test
DATA LIST / ACTIVE TEST
1. DATA LIST
Using the Techstream to read the Data List allows the values or states of switches,
sensors, actuators and other items to be read without removing any parts. This non-intrusive
inspection can be very useful because in ...
Basic Inspection
BASIC INSPECTION
When the malfunction is not confirmed by the DTC check, troubleshooting should
be carried out in all circuits considered to be possible causes of the problem.
In many cases, by carrying out the basic engine check shown in the following pr ...
Installation
INSTALLATION
PROCEDURE
1. INSTALL DRIVE MONITOR SWITCH
(a) Engage the 4 claws to install the driver monitor switch.
2. INSTALL RADIO AND DISPLAY RECEIVER ASSEMBLY WITH BRACKET (for Radio and Display ...