INSTALLATION
CAUTION / NOTICE / HINT
HINT:
PROCEDURE
1. INSTALL REAR AXLE CARRIER SUB-ASSEMBLY
(a) Temporarily install the rear axle carrier sub-assembly with the 2 bolts and 2 nuts. NOTICE:
|
|
(b) Install the rear axle carrier sub-assembly with the 2 bolts and 2 nuts. Torque: 290 N·m {2957 kgf·cm, 214 ft·lbf} NOTICE:
HINT: Insert the bolts from the rear side. |
|
(c) Fully tighten the rear No. 2 suspension arm assembly and the rear No. 1 suspension arm assembly with the 2 bolts and 2 nuts. Torque: 112 N·m {1141 kgf·cm, 82 ft·lbf} NOTICE: Since stopper nuts are used, tighten the bolts. |
|
2. INSTALL REAR STRUT ROD ASSEMBLY
3. INSTALL NO. 3 PARKING BRAKE CABLE ASSEMBLY
4. INSTALL REAR AXLE HUB AND BEARING ASSEMBLY
5. INSTALL REAR SPEED SENSOR
6. INSTALL REAR DISC
7. INSTALL REAR DISC BRAKE CALIPER ASSEMBLY
8. INSTALL REAR AXLE SHAFT NUT
9. INSTALL REAR WHEEL
Torque:
103 N·m {1050 kgf·cm, 76 ft·lbf}
10. STABILIZE SUSPENSION
11. INSPECT AND ADJUST REAR WHEEL ALIGNMENT
(a) Inspect and adjust the front wheel alignment (See page ).
12. CHECK FOR SPEED SENSOR SIGNAL
(a) Check for the speed sensor signal (See page ).
On-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT CENTER AIRBAG SENSOR ASSEMBLY (VEHICLE NOT INVOLVED IN COLLISION)
(a) Perform a diagnostic system check (See page
).
2. INSPECT CENTER AIRBAG SENSOR ASSEMBLY (VEHICLE INVOLVED IN COLLISION AND AIRBAG
HAS NOT D ...
Engine Coolant Temperature Circuit Range / Performance Problem (P0116)
DESCRIPTION
Refer to DTC P0115 (See page ).
DTC No.
DTC Detection Condition
Trouble Area
P0116
When either of the following conditions is met (2 trip detection logic).
During engine ...
Disassembly
DISASSEMBLY
CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the RH side and the LH side.
The procedure listed below is for the LH side.
PROCEDURE
1. REMOVE REAR WHEEL
2. REMOVE REAR AXLE SHAFT NUT (for AWD)
NOTICE:
Perform th ...