INSTALLATION
PROCEDURE
1. INSTALL PARKING BRAKE PEDAL ASSEMBLY
(a) Install the parking brake pedal assembly with the 3 nuts. Torque: 21 N·m {214 kgf·cm, 15 ft·lbf} |
|
(b) Connect the parking brake switch connector. |
|
(c) Install the No. 1 parking brake cable assembly with the nut and 4 bolts.
Torque:
Nut :
5.4 N·m {55 kgf·cm, 48 in·lbf}
Bolt :
15 N·m {153 kgf·cm, 11 ft·lbf}
(d) Temporarily install the No. 1 wire adjusting nut and lock nut. Text in Illustration
HINT: After adjusting parking brake pedal travel, tighten the lock nut. |
|
(e) Engage the 4 clamps to install the wire harness. |
|
(f) Connect the 2 connectors. |
|
(g) Connect the heated oxygen sensor connector and engage the 2 clamps (for 2GR-FE). |
|
2. CONNECT NO. 4 PARKING BRAKE CABLE ASSEMBLY
(a) Holding the lock nut of the No. 1 parking brake cable assembly, tighten the turnbuckle of the No. 4 parking brake cable assembly to connect the No. 4 parking brake cable assembly to the No. 1 parking brake cable assembly. Text in Illustration
Torque: 5.4 N·m {55 kgf·cm, 48 in·lbf} |
|
3. INSTALL FRONT NO. 2 FLOOR SILENCER
(a) Install the front No. 2 floor silencer. |
|
4. INSTALL REAR NO. 1 AIR DUCT
5. INSTALL REAR NO. 2 AIR DUCT
6. INSTALL YAW RATE AND ACCELERATION SENSOR
HINT:
Refer to the instructions for Installation of the yaw rate and acceleration sensor (See page ).
7. ADJUST PARKING BRAKE SHOE CLEARANCE AND PARKING BRAKE PEDAL TRAVEL
8. INSPECT BRAKE WARNING LIGHT
Knock Sensor 1 Circuit Low Input (Bank 1 or Single Sensor) (P0327,P0328)
DESCRIPTION
Flat-type knock sensors (non-resonant type) have structures that can detect vibrations
between approximately 5 and 15 kHz.
Knock sensors are fitted onto the engine block to detect engine knocking.
The knock sensor contains a piezoelectric elem ...
Audio system types
► Vehicles with Display Audio system
Type A
Type B
Refer to the “Display Audio System Owner’s Manual”.
► Vehicles with a navigation system
Refer to the “Navigation System Owner’s Manual”. ...
On-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT WINDSHIELD WIPER MOTOR ASSEMBLY
(a) for RH Side
(1) Operate the windshield wiper motor assembly.
(2) Stop the windshield wiper motor assembly operation.
...