INSTALLATION
PROCEDURE
1. INSTALL BRAKE PEDAL SUPPORT ASSEMBLY
(a) Install the brake pedal support assembly to the instrument panel reinforcement with the bolt. Torque: 19 N·m {195 kgf·cm, 14 ft·lbf} |
|
(b) Connect the connector. |
|
2. INSTALL STOP LIGHT SWITCH MOUNTING ADJUSTER
3. INSTALL STOP LIGHT SWITCH ASSEMBLY
4. INSTALL HEADLIGHT LEVELING ECU ASSEMBLY (w/ HID Headlight System)
5. INSTALL BRAKE BOOSTER ASSEMBLY
HINT:
Refer to the instructions for Installation of the brake booster assembly (See page ).
Rear Left Center Sensor Malfunction (C1AE7)
DESCRIPTION
The No. 1 ultrasonic sensor (rear left center sensor) is installed on the rear
bumper. The ECU detects obstacles based on signals received from the No. 1 ultrasonic
sensor (rear left center sensor). If the No. 1 ultrasonic sensor (rear left ce ...
Propeller Shaft System
Problem Symptoms Table
PROBLEM SYMPTOMS TABLE
HINT:
Use the table below to help determine the cause of problem symptoms. If multiple
suspected areas are listed, the potential causes of the symptoms are listed in order
of probability in the "Suspe ...
Disassembly
DISASSEMBLY
PROCEDURE
1. REMOVE SLIDING ROOF HOUSING CENTER FRAME
(a) Remove the 2 nuts and sliding roof housing center frame.
2. REMOVE NO. 4 SUNSHADE TRIM SUB-ASSEMBLY
(a) Remove the s ...