INSTALLATION
PROCEDURE
1. INSTALL YAW RATE AND ACCELERATION SENSOR
(a) Install the yaw rate and acceleration sensor to the bracket with the 2 nuts. Torque: 5.0 N·m {51 kgf·cm, 44 in·lbf} |
|
(b) Install the yaw rate and acceleration sensor with bracket with the 2 bolts. Torque: 13 N·m {127 kgf·cm, 9 ft·lbf} NOTICE:
|
|
(c) Connect the connector to the yaw rate and acceleration sensor.
NOTICE:
Make sure that the yaw rate and acceleration sensor connector is connected securely.
2. INSTALL NO. 4 CENTER MEMBER FLOOR REINFORCE SUB-ASSEMBLY
(a) Install the No. 4 center member floor reinforce sub-assembly with the 7 bolts. Torque: 19 N·m {194 kgf·cm, 14 ft·lbf} |
|
(b) Return the floor carpet assembly to an original state.
3. INSTALL CONSOLE BOX SUB-ASSEMBLY
4. INSTALL POSITION INDICATOR HOUSING ASSEMBLY
5. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY
6. INSTALL LOWER INSTRUMENT PANEL SUB-ASSEMBLY
7. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
8. INSTALL COWL SIDE TRIM SUB-ASSEMBLY RH
9. INSTALL FRONT DOOR SCUFF PLATE RH
10. INSTALL LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL
11. INSTALL COWL SIDE TRIM SUB-ASSEMBLY LH
12. INSTALL FRONT DOOR SCUFF PLATE LH
13. INSTALL AIR CONDITIONING CONTROL ASSEMBLY
14. INSTALL CONSOLE BOX ASSEMBLY
15. INSTALL NO. 2 CONSOLE BOX CARPET
16. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY (w/o Seat Heater System)
17. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY (w/ Seat Heater System)
18. INSTALL FRONT SEAT ASSEMBLY LH (for Manual Seat)
HINT:
Refer to the instructions for Installation of the front seat assembly LH (See page ).
19. INSTALL FRONT SEAT ASSEMBLY LH (for Power Seat)
HINT:
Refer to the instructions for Installation of the front seat assembly LH (See page )
20. INSTALL FRONT SEAT ASSEMBLY RH (for Manual Seat)
HINT:
Perform the same procedure as the LH side.
21. INSTALL FRONT SEAT ASSEMBLY RH (for Power Seat)
HINT:
Perform the same procedure as the LH side.
22. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).
23. INSPECT SRS WARNING LIGHT
HINT:
(See page ).
Removal
REMOVAL
CAUTION / NOTICE / HINT
HINT:
When installing new name plates and emblem, heat the vehicle body, name plates
and emblem using a heat light.
Heating Temperature
Item
Temperature
Vehicle Body
40 to ...
Transmission Control Switch Circuit
DESCRIPTION
When the shift lever is in S and it is moved toward "-" or "+", it is possible
to select different shift ranges (1st through 6th ranges).
Moving the shift lever toward "+" increases the shift range by one, and movi ...
If you have a flat tire
Remove the flat tire and replace it with the spare provided. - Before
jacking up the vehicle
• Stop the vehicle on a hard, flat surface.
• Set the parking brake.
• Shift the shift lever to “P”.
• Stop the engine.
• Turn on the emergency f ...