INSTALLATION
CAUTION / NOTICE / HINT
HINT:
PROCEDURE
1. INSTALL REAR SPEED SENSOR
(a) Install the rear speed sensor with the bolt. Torque: 8.5 N·m {87 kgf·cm, 75 in·lbf} NOTICE:
|
|
(b) Install the No. 1 clamp and No. 2 clamp with the 2 bolts. Torque: 8.0 N·m {82 kgf·cm, 71 in·lbf} NOTICE: Do not twist the rear speed sensor wire when installing the clamps. Text in Illustration
|
|
(c) Insert the connector and grommet to the inside of the vehicle through the passage hole in the wheel well.
NOTICE:
Make sure that the grommet's band clamp remains on the outside of the vehicle.
(d) Hold the grommet and pull it from the inside to the outside of the vehicle. Then secure it in place so that it is not tilted.
NOTICE:
When pulling out the grommet, do not grip the sensor wire.
(e) Connect the rear speed sensor connector. Text in Illustration
|
|
2. INSTALL DECK TRIM SIDE PANEL ASSEMBLY LH
3. CONNECT REAR SEAT OUTER BELT ASSEMBLY LH
4. INSTALL LUGGAGE HOLD BELT STRIKER ASSEMBLY
5. INSTALL RECLINING REMOTE CONTROL BEZEL LH
6. INSTALL REAR FLOOR FINISH PLATE
7. INSTALL REAR SEAT SUB FLOOR PANEL ASSEMBLY
8. INSTALL NO. 1 DECK BOARD
9. INSTALL DECK SIDE TRIM BOX RH
10. INSTALL NO. 2 DECK BOARD SUB-ASSEMBLY
11. INSTALL DECK SIDE TRIM BOX LH
12. INSTALL NO. 3 DECK BOARD SUB-ASSEMBLY
13. INSTALL DECK BOARD ASSEMBLY
14. INSTALL TONNEAU COVER ASSEMBLY (w/ Tonneau Cover)
15. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP LH
16. INSTALL REAR DOOR SCUFF PLATE LH
17. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).
18. CHECK FOR SPEED SENSOR SIGNAL
HINT:
(See page ).
Side doors
The vehicle can be locked and unlocked using the entry function, wireless
remote control, key or door lock switch.
- Entry function (vehicles with smart key system)
- Wireless remote control
- Key
► Vehicles with smart key system ...
Repair
REPAIR
PROCEDURE
1. REPAIR INTAKE VALVE SEAT
NOTICE:
Repair the seat while checking the seating position.
Keep the lip free of foreign matter.
Take off the cutter gradually to make the intake valve seat smooth.
(a) Usin ...
Inspection
INSPECTION
PROCEDURE
1. INSPECT CYLINDER HEAD SUB-ASSEMBLY
(a) Using a precision straightedge and feeler gauge, measure the warpage of the
contact surfaces where the cylinder head contacts the cylinder block and manifold.
Maximum Warpage:
...