INSTALLATION
PROCEDURE
1. INSTALL NAVIGATION RECEIVER ASSEMBLY
2. INSTALL NO. 2 RADIO RECEIVER BRACKET
(a) Install the No. 2 radio receiver bracket with the 4 screws.
Torque:
5.0 N·m {51 kgf·cm, 44 in·lbf}
3. INSTALL NO. 1 RADIO RECEIVER BRACKET
(a) Install the No. 1 radio receiver bracket with the 4 screws.
Torque:
5.0 N·m {51 kgf·cm, 44 in·lbf}
4. INSTALL STEREO COMPONENT TUNER ASSEMBLY WITH WIRE (w/ Satellite Radio)
5. INSTALL INSTRUMENT CLUSTER CENTER FINISH PANEL SUB-ASSEMBLY
(a) Engage the 4 claws.
(b) Install the instrument cluster center finish panel sub-assembly with the 4 screws.
6. INSTALL NAVIGATION RECEIVER ASSEMBLY WITH BRACKET
(a) Connect each connector.
(b) Engage the 2 clips.
(c) Install the navigation receiver assembly with bracket with the 4 bolts.
Torque:
11 N·m {112 kgf·cm, 8 ft·lbf}
7. INSTALL NO. 2 INSTRUMENT PANEL SPEAKER PANEL SUB-ASSEMBLY
8. INSTALL CONSOLE BOX SUB-ASSEMBLY
9. INSTALL POSITION INDICATOR HOUSING ASSEMBLY
10. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY
11. INSTALL LOWER INSTRUMENT PANEL SUB-ASSEMBLY
12. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
13. INSTALL COWL SIDE TRIM SUB-ASSEMBLY RH
14. INSTALL FRONT DOOR SCUFF PLATE RH
15. INSTALL AIR CONDITIONING CONTROL ASSEMBLY
16. INSTALL CONSOLE BOX ASSEMBLY
17. INSTALL NO. 2 CONSOLE BOX CARPET
18. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY (w/o Seat Heater System)
19. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY (w/ Seat Heater System)
20. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).
Communication Malfunction No. 1 (B2797)
DESCRIPTION
This DTC is stored when an error occurs in communication between the transponder
key amplifier and the transponder key ECU assembly.
HINT:
Some noise is found in the communication line.
DTC No.
DTC Detection Condition
...
Disassembly
DISASSEMBLY
PROCEDURE
1. REMOVE SLIDING ROOF HOUSING CENTER FRAME
(a) Remove the 2 nuts and sliding roof housing center frame.
2. REMOVE NO. 4 SUNSHADE TRIM SUB-ASSEMBLY
(a) Remove the s ...
Diagnosis System
DIAGNOSIS SYSTEM
1. CHECK DLC3
(a) Check the DLC3 (See page ).
2. FUNCTION OF P/S WARNING LIGHT
(a) When a malfunction is detected in the power steering system, the P/S warning
light on the accessory meter comes on to inform the driver of the malfunctio ...