INSTALLATION
PROCEDURE
1. INSTALL RADIO AND DISPLAY RECEIVER ASSEMBLY
2. INSTALL NO. 2 RADIO RECEIVER BRACKET
(a) Install the No. 2 radio receiver bracket with the 4 screws.
Torque:
5.0 N·m {51 kgf·cm, 44 in·lbf}
3. INSTALL NO. 1 RADIO RECEIVER BRACKET
(a) Install the No. 1 radio receiver bracket with the 4 screws.
Torque:
5.0 N·m {51 kgf·cm, 44 in·lbf}
4. INSTALL STEREO COMPONENT TUNER ASSEMBLY WITH WIRE (w/ Satellite Radio)
5. INSTALL INSTRUMENT CLUSTER CENTER FINISH PANEL SUB-ASSEMBLY
(a) Engage the 4 claws.
(b) Install the instrument cluster center finish panel sub-assembly with the 4 screws.
6. INSTALL RADIO AND DISPLAY RECEIVER ASSEMBLY WITH BRACKET
(a) Connect each connector.
(b) Engage the 2 clips.
(c) Install the radio and display receiver assembly with bracket with the 4 bolts.
Torque:
11 N·m {112 kgf·cm, 8 ft·lbf}
7. INSTALL NO. 2 INSTRUMENT PANEL SPEAKER PANEL SUB-ASSEMBLY
8. INSTALL CONSOLE BOX SUB-ASSEMBLY
9. INSTALL POSITION INDICATOR HOUSING ASSEMBLY
10. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY
11. INSTALL LOWER INSTRUMENT PANEL SUB-ASSEMBLY
12. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
13. INSTALL COWL SIDE TRIM SUB-ASSEMBLY RH
14. INSTALL FRONT DOOR SCUFF PLATE RH
15. INSTALL AIR CONDITIONING CONTROL ASSEMBLY
16. INSTALL CONSOLE BOX ASSEMBLY
17. INSTALL NO. 2 CONSOLE BOX CARPET
18. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY (w/o Seat Heater System)
19. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY (w/ Seat Heater System)
Dtc Check / Clear
DTC CHECK / CLEAR
1. CHECK DTC (CHECK USING TECHSTREAM)
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON.
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / Navigation System / Trouble
Codes.
(e) Chec ...
Rear Occupant Classification Sensor LH Circuit Malfunction (B1782)
DESCRIPTION
The rear occupant classification sensor LH circuit consists of the occupant classification
ECU and rear occupant classification sensor LH.
DTC B1782 is recorded when a malfunction is detected in the rear occupant classification
sensor LH circ ...
Radio Broadcast cannot be Received or Poor Reception
PROCEDURE
1.
CHECK NAVIGATION RECEIVER ASSEMBLY
(a) Check the radio automatic station search function.
(1) Check the radio automatic station search function by activating it.
Result
Proceed to
...