INSTALLATION
PROCEDURE
1. INSTALL REAR NO. 3 SPEAKER ASSEMBLY
(a) Install the rear No. 3 speaker assembly with the 2 bolts. |
|
(b) Engage the clamp.
2. INSTALL ROOF SIDE INNER GARNISH ASSEMBLY LH
3. INSTALL DECK TRIM SIDE PANEL ASSEMBLY LH
4. CONNECT REAR SEAT OUTER BELT ASSEMBLY LH
5. INSTALL LUGGAGE HOLD BELT STRIKER ASSEMBLY (for LH Side)
6. INSTALL RECLINING REMOTE CONTROL BEZEL LH
7. INSTALL REAR SEAT ASSEMBLY LH
8. CONNECT REAR SEAT NO. 2 RECLINING CONTROL CABLE SUB-ASSEMBLY
9. INSTALL REAR SEAT OUTER TRACK BRACKET COVER
10. INSTALL REAR SEAT INNER TRACK BRACKET COVER
11. INSTALL REAR SEAT HEADREST ASSEMBLY
12. INSTALL REAR FLOOR FINISH PLATE
13. INSTALL REAR SEAT SUB FLOOR PANEL ASSEMBLY
14. INSTALL NO. 1 DECK BOARD
15. INSTALL DECK SIDE TRIM BOX RH
16. INSTALL NO. 2 DECK BOARD SUB-ASSEMBLY
17. INSTALL DECK SIDE TRIM BOX LH
18. INSTALL NO. 3 DECK BOARD SUB-ASSEMBLY
19. INSTALL DECK BOARD ASSEMBLY
20. INSTALL TONNEAU COVER ASSEMBLY (w/ Tonneau Cover)
21. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP LH
22. INSTALL REAR DOOR SCUFF PLATE LH
Removal
REMOVAL
PROCEDURE
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-)
battery terminal to disable the SRS system.
NOTICE:
When disconnecting the cable, some systems ne ...
Atf Temperature Sensor(when Using The Engine Support Bridge)
Components
COMPONENTS
ILLUSTRATION
Inspection
INSPECTION
PROCEDURE
1. INSPECT ATF TEMPERATURE SENSOR ASSEMBLY
(a) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester C ...
Removal
REMOVAL
PROCEDURE
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-)
battery terminal to disable the SRS system.
NOTICE:
When disconnecting the cable, some systems ne ...