INSTALLATION
PROCEDURE
1. INSTALL STEERING PAD
(a) Check that the ignition switch is off.
(b) Check that the cable is disconnected from the negative (-) battery terminal.
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
(c) Connect the 2 airbag connectors to the steering pad. Text in Illustration
NOTICE:
|
|
(d) Push in the 2 airbag connector locks to install the 2 airbag connectors.
(e) Connect the horn connector to the steering pad.
(f) Push the steering pad to engage the 3 pins carefully. NOTICE:
|
|
2. INSTALL LOWER NO. 3 STEERING WHEEL COVER
(a) Engage the claw and guide to install the lower No. 3 steering wheel cover.
3. INSTALL LOWER NO. 2 STEERING WHEEL COVER
(a) Engage the claw and guide to install the lower No. 2 steering wheel cover.
4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).
5. INSPECT STEERING PAD
(a) Make sure that the horn sounds.
HINT:
If the horn does not sound, inspect the horn system (See page ).
6. PERFORM DIAGNOSTIC SYSTEM CHECK
(See page )
7. INSPECT SRS WARNING LIGHT
(See page )
Problem Symptoms Table
PROBLEM SYMPTOMS TABLE
HINT:
Use the table below to help determine the cause of problem symptoms.
If multiple suspected areas are listed, the potential causes of the symptoms
are listed in order of probability in the "Suspected Area" ...
Installation
INSTALLATION
PROCEDURE
1. INSTALL REAR NO. 2 SPEAKER ASSEMBLY (for 13 Speakers)
(a) Install the rear No. 2 speaker assembly with the 2 screws.
(b) Engage the clamp.
2. INSTALL REAR SPEAKER BRACKET ...
Dtc Check / Clear
DTC CHECK / CLEAR
1. DTC CHECK/CLEAR (When Using the Techstream)
(a) Check for DTCs.
(1) Connect the Techstream to the DLC3.
(2) Turn the ignition switch to ON.
(3) Turn the Techstream on.
(4) Read the DTCs following the prompts on the Techstream. Enter ...