INSTALLATION
PROCEDURE
1. INSTALL SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY
NOTICE:
(a) Check that the front wheels are facing straight ahead.
(b) Set the turn signal switch to the neutral position.
NOTICE:
If it is not in the neutral position, the turn signal switch pin may snap.
(c) Install the spiral cable with sensor sub-assembly with the 3 claws. NOTICE: When replacing the spiral cable with sensor sub-assembly with a new one, remove the lock pin before installing the steering wheel assembly. |
|
(d) Connect the connectors to the spiral cable with sensor sub-assembly.
NOTICE:
When connecting any airbag connector, take care not to damage the airbag wire harness.
2. INSTALL UPPER STEERING COLUMN COVER
3. INSTALL LOWER STEERING COLUMN COVER
4. TURN FRONT WHEELS TO FACE STRAIGHT AHEAD
5. ADJUST SPIRAL CABLE
(a) Check that the ignition switch is off.
(b) Check that the cable is disconnected from the negative (-) battery terminal.
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
(c) Rotate the spiral cable counterclockwise slowly by hand until it stops. NOTICE: Do not turn the spiral cable using the airbag wire harness. |
|
(d) Rotate the spiral cable clockwise approximately 2.5 turns to align the alignment marks. Text in Illustration
NOTICE: Do not turn the spiral cable using the airbag wire harness. HINT: The spiral cable will rotate approximately 2.5 turns to both the left and right from the center. |
|
6. INSTALL STEERING WHEEL ASSEMBLY
7. INSTALL STEERING PAD
8. INSTALL LOWER NO. 3 STEERING WHEEL COVER
9. INSTALL LOWER NO. 2 STEERING WHEEL COVER
10. INSPECT STEERING WHEEL CENTER POINT
11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).
12. INSPECT STEERING PAD
13. PERFORM DIAGNOSTIC SYSTEM CHECK
(a) Perform a diagnostic system check (See page ).
14. INSPECT SRS WARNING LIGHT
(a) Inspect the SRS warning light (See page ).
Reassembly
REASSEMBLY
PROCEDURE
1. INSTALL MULTIPLEX NETWORK DOOR ECU
(a) Connect the connector and install the multiplex network door ECU.
(b) Install the flat cable connector as shown in the illus ...
Jam Protection Function Activates During Power Back Door Operation
DESCRIPTION
When the jam protection function activates during power back door operation,
one of the following may be the cause: 1) improper fit of back door, or a foreign
object is stuck in the back door, 2) malfunctioning power back door touch sensor
c ...
Fuel Receiver Gauge Malfunction
DESCRIPTION
The meter CPU uses the fuel sender gauge assembly to determine the level
of the fuel in the fuel tank. The resistance of the fuel sender gauge will
vary between approximately 7.5 Ω with the float at the full position, and
185 Î ...