INSTALLATION
PROCEDURE
1. INSTALL DRIVER SIDE KNEE AIRBAG ASSEMBLY
(a) Check that the ignition switch is off.
(b) Check that the cable is disconnected from the negative (-) battery terminal.
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
(c) Connect the driver side knee airbag connector to the driver side knee airbag assembly. Text in Illustration
NOTICE: When connecting the airbag connector, take care not to damage the airbag wire harness. |
|
(d) Connect the DLC3 to the driver side knee airbag assembly with the 2 claws.
(e) Temporarily install the driver side knee airbag assembly with the 2 hooks. |
|
(f) Install the driver side knee airbag assembly with the 4 bolts.
Torque:
10 N·m {102 kgf·cm, 7 ft·lbf}
2. INSTALL LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL
3. INSTALL COWL SIDE TRIM SUB-ASSEMBLY LH
4. INSTALL FRONT DOOR SCUFF PLATE LH
5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).
6. PERFORM DIAGNOSTIC SYSTEM CHECK
(a) Perform a diagnostic system check (See page ).
7. INSPECT SRS WARNING LIGHT
(a) Inspect the SRS warning light (See page ).
Inspection
INSPECTION
PROCEDURE
1. INSPECT FRONT STABILIZER LINK ASSEMBLY
(a) Inspect the turning torque of the ball joint.
(1) Secure the front stabilizer link assembly in a vise using aluminum
plates.
(2) Install the nut to the front stabilizer ...
Problem Symptoms Table
PROBLEM SYMPTOMS TABLE
HINT:
Use the table below to help determine the cause of problem symptoms.
If multiple suspected areas are listed, the potential causes of the symptoms
are listed in order of probability in the "Suspected Area" ...
How To Proceed With Troubleshooting
CAUTION / NOTICE / HINT
HINT:
Use the following procedure to troubleshoot the window defogger system.
*: Use the Techstream.
PROCEDURE
1.
VEHICLE BROUGHT TO WORKSHOP
NEXT
...