Toyota Venza: Installation
INSTALLATION
CAUTION / NOTICE / HINT
CAUTION:
- The nuts must not be reused.
- Make sure that the front seat frame assembly with adjuster is not deformed. If it is, replace it with a new one.
PROCEDURE
1. INSTALL FRONT SEAT SIDE AIRBAG ASSEMBLY
|
(a) Install the front seat side airbag assembly with 2 new nuts. Torque: 8.0 N·m {82 kgf·cm, 71 in·lbf} |
|
.png)
(b) Engage the 2 clamps to connect the wire harness.
|
(c) Engage the 4 clamps to connect the wire harness. Text in Illustration
|
|
.png)
2. INSTALL SEPARATE TYPE FRONT SEATBACK COVER WITH PAD (for Manual Seat)
.gif)
3. INSTALL SEPARATE TYPE FRONT SEATBACK COVER WITH PAD (for Power Seat)
4. INSTALL FRONT SEATBACK BOARD SUB-ASSEMBLY (for Manual Seat)
5. INSTALL FRONT SEATBACK BOARD SUB-ASSEMBLY (for Power Seat)
6. INSTALL FRONT SEAT ASSEMBLY (for Manual Seat)
(See page )
7. INSTALL FRONT SEAT ASSEMBLY (for Power Seat)
(See page )
Disposal
DISPOSAL
CAUTION / NOTICE / HINT
CAUTION:
Before performing pre-disposal deployment of any SRS component, review and closely
follow all applicable environmental and hazardous material regulations ...
Other materials about Toyota Venza:
Key battery
Replace the battery with a new one if it is discharged.
- You will need the following items:
• Flathead screwdriver (To prevent damage to the key, cover the tip of the screwdriver
with rag.)
• Small Phillips-head screwdriver
• Lithium battery ...
System Diagram
SYSTEM DIAGRAM
Communication Table
Transmitting ECU
Receiving ECU
Signal
Communication Method
Air Conditioning Control Assembly
Air Conditioning Amplifier Assembly
Rear windo ...
Electrical Key Oscillator(for Rear Side)
Components
COMPONENTS
ILLUSTRATION
Removal
REMOVAL
PROCEDURE
1. REMOVE REAR BUMPER PLATE LH
2. REMOVE REAR BUMPER PLATE RH
3. REMOVE REAR BUMPER ASSEMBLY
4. REMOVE ELECTRICAL KEY ANTENNA
(a) Disconnect the connector.
...
0.1357