Toyota Venza manuals

Toyota Venza: Installation

INSTALLATION

PROCEDURE

1. INSTALL INSTRUMENT PANEL WIRE ASSEMBLY

(a) Connect the vent hole connector of the instrument panel wire to the front passenger airbag assembly.

Text in Illustration

*1

Vent Hole Connector Lock

*2

Vent Hole Connector

NOTICE:

When connecting any airbag connector, take care not to damage the airbag wire harness.


(b) Push in the vent hole connector lock to install the vent hole connector.

(c) Connect the 2 airbag connectors of the instrument panel wire to the front passenger airbag assembly.

Text in Illustration

*1

Airbag Connector Lock

*2

Airbag Connector

NOTICE:

  • When connecting any airbag connector, take care not to damage the airbag wire harness.
  • Be sure to only connect the connectors to each corresponding color.

(d) Push in the 2 airbag connector locks to install the 2 airbag connectors.

(e) Engage the 2 clamps.

2. INSTALL FRONT PASSENGER AIRBAG ASSEMBLY

(a) Engage the 5 hooks.

(b) Push in the front passenger airbag assembly to engage the 5 hooks.

(c) Install the 2 screws to install the front passenger airbag assembly.

3. INSTALL INSTRUMENT PANEL SAFETY PAD ASSEMBLY


4. CONNECT INSTRUMENT PANEL WIRE ASSEMBLY

(a) Check that the ignition switch is off.

(b) Check that the cable is disconnected from the negative (-) battery terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

(c) Connect the 2 connectors.

NOTICE:

When connecting the airbag connector, take care not to damage the airbag wire harness.


5. INSTALL SHIFT LEVER ASSEMBLY

(See page )


6. PERFORM DIAGNOSTIC SYSTEM CHECK

(See page )


7. INSPECT SRS WARNING LIGHT

(See page )


Removal
REMOVAL PROCEDURE 1. PRECAUTION NOTICE: Be sure to read Precaution thoroughly before servicing (See page ). 2. REMOVE SHIFT LEVER ASSEMBLY (See page ) 3. DISCONNECT INSTRUMENT PANEL WIRE ASS ...

Disposal
DISPOSAL CAUTION / NOTICE / HINT CAUTION: Before performing pre-disposal deployment of any SRS component, review and closely follow all applicable environmental and hazardous material regulations ...

Other materials about Toyota Venza:

Problem Symptoms Table
PROBLEM SYMPTOMS TABLE HINT: Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" ...

Installation
INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH side and LH side. The procedure listed below is for the LH side. PROCEDURE 1. INSTALL REAR AXLE CARRIER SUB-ASSEMBLY (a) Temporarily install the rea ...

Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART Intuitive Parking Assist System DTC Code Detection Item See page C1AE1 Front Left Sensor Malfunction C1AE4 Front Right Sensor ...

© 2016-2024 Copyright www.tovenza.com

0.1431