INSTALLATION
CAUTION / NOTICE / HINT
HINT:
PROCEDURE
1. INSTALL CURTAIN SHIELD AIRBAG ASSEMBLY
(a) Check that the ignition switch is off.
(b) Check that the cable is disconnected from the negative (-) battery terminal.
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
(c) Engage the 13 hooks to temporarily install the curtain shield airbag assembly.
NOTICE:
Do not twist the curtain shield airbag assembly when installing it.
(d) Install 8 new bolts.
Torque:
11 N·m {112 kgf·cm, 8 ft·lbf}
(e) Connect the curtain shield airbag connector.
NOTICE:
When connecting the airbag connector, take care not to damage the airbag wire harness.
2. INSTALL ROOF HEADLINING ASSEMBLY
HINT:
Refer to the procedure from Install Roof Headlining Assembly (See page ).
3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).
4. PERFORM DIAGNOSTIC SYSTEM CHECK
(a) Perform a diagnostic system check (See page ).
5. INSPECT SRS WARNING LIGHT
(a) Inspect the SRS warning light (See page ).
Lost Communication with Automatic High Beam Sensor (B2432)
DESCRIPTION
The DTC is stored when the AFS ECU (headlight swivel ECU assembly) detects malfunctions
in the LIN communication system.
DTC No.
DTC Detection Condition
Trouble Area
B2432
Malfunction ...
Precaution
PRECAUTION
NOTICE:
When disconnecting the cable from the negative (-) battery terminal, initialize
the following systems after the cable is reconnected.
System Name
See Procedure
Back Door Closer System
...
Locking the driver’s doors from the outside without a key
Move the inside lock button to the
lock position.
Close the door.
►Vehicles with smart key system
The door cannot be locked if the “ENGINE START STOP” switch is in ACCESSORY or IGNITION
ON mode, or the electronic key is left inside the vehic ...