INSTALLATION
PROCEDURE
1. INSTALL REAR SEAT INNER BELT ASSEMBLY RH
(a) Install the rear seat inner belt assembly RH with the bolt. Torque: 42 N·m {428 kgf·cm, 31 ft·lbf} |
|
2. INSTALL REAR SEAT CUSHION COVER WITH PAD
3. INSTALL REAR SEAT CENTER ARMREST ASSEMBLY
4. INSTALL REAR SEAT RECLINING COVER RH
5. INSTALL CENTER SEAT HINGE COVER RH
6. INSTALL REAR SEAT INNER RECLINING COVER RH
7. INSTALL REAR SEAT RECLINING RELEASE LEVER RH
8. INSTALL SEAT ADJUSTER COVER CAP RH
9. INSTALL REAR SEAT ASSEMBLY RH
10. CONNECT REAR SEAT RECLINING CONTROL CABLE SUB-ASSEMBLY
11. INSTALL REAR SEAT OUTER TRACK BRACKET COVER
12. INSTALL REAR SEAT INNER TRACK BRACKET COVER
13. INSTALL REAR SEAT CENTER HEADREST ASSEMBLY
14. INSTALL REAR SEAT HEADREST ASSEMBLY
Transmitter ID1 Operation Stop (C2111/11-C2114/14)
DESCRIPTION
The tire pressure warning valve and transmitter installed in each tire and wheel
assembly measures the tire pressures. The measured values are transmitted as radio
waves to the tire pressure warning antenna and receiver on the body and then se ...
Follow the correction procedures. (smart key system)
After taking the specified steps to correct the suspected problem, check that
the warning light turns off.
- If the malfunction indicator lamp comes on while driving
First check the following:
• Is the fuel empty?
If it is, fill the fuel tan ...
Tachometer Malfunction
DESCRIPTION
In this circuit, the meter CPU receives engine speed signals from the ECM using
the CAN communication system (CAN No. 1 Bus). The meter CPU displays the engine
speed calculated based on the data received from the ECM.
WIRING DIAGRAM
PROCED ...