Toyota Venza manuals

Toyota Venza: Installation

INSTALLATION

PROCEDURE

1. INSTALL REAR SEAT ASSEMBLY LH

(a) Place the rear seat assembly LH in the cabin.

NOTICE:

Be careful not to damage the vehicle body.

(b) Temporarily install the 2 bolts on the front side of the seat.


(c) Temporarily install the 2 bolts on the rear side of the seat.


(d) Install the rear seat assembly LH with the 4 bolts.

Torque:

37 N·m {377 kgf·cm, 27 ft·lbf}

2. CONNECT REAR SEAT NO. 2 RECLINING CONTROL CABLE SUB-ASSEMBLY

(a) Remove the rear seat No. 2 reclining control cable from the carpet hole.


(b) Connect the rear seat No. 2 reclining control cable sub-assembly as shown in the illustration.

Text in Illustration

*1

Protective Tape

*2

Seat Track Adjusting Handle

(c) Engage the 2 claws and connect the rear seat No. 2 reclining control cable sub-assembly as shown in the illustration.


(d) Return the seatback to the upright position.

(e) Pull up the adjuster's lock piece to lock it as shown in the illustration.

Text in Illustration

*1

Adjuster Spring

*2

Lock Piece

NOTICE:

When pressing the lock piece, make sure the adjuster's spring is not compressed.

3. INSTALL REAR SEAT OUTER TRACK BRACKET COVER

(a) Engage the guide and 3 claws and install the rear seat outer track bracket cover as shown in the illustration.


4. INSTALL REAR SEAT INNER TRACK BRACKET COVER

(a) Engage the guide and 3 claws and install the rear seat inner track bracket cover as shown in the illustration.


5. INSTALL REAR SEAT HEADREST ASSEMBLY

(a) Install the rear seat headrest assembly as shown in the illustration.


Disassembly
DISASSEMBLY PROCEDURE 1. REMOVE SEAT ADJUSTER COVER CAP LH (a) Using a screwdriver wrapped with protective tape, disengage the 3 claws and remove the seat adjuster cover cap LH. T ...

Rear Seat Assembly(for Rh Side)
...

Other materials about Toyota Venza:

Removal
REMOVAL PROCEDURE 1. PRECAUTION CAUTION: Be sure to read Precaution thoroughly before servicing (See page ). NOTICE: After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery term ...

Installation
INSTALLATION PROCEDURE 1. INSTALL REAR ENGINE OIL SEAL (a) Apply MP grease to the lip of a new oil seal. NOTICE: Do not allow foreign matter to contact the lip of the oil seal. Do not allow MP grease to contact the dust seal. ...

Interior Light Auto Cut Circuit
DESCRIPTION When battery saving control operates while the interior lights are on, the main body ECU (driver side junction block assembly) opens the DOME CUT relay to turn off the lights. WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE: Inspect the fu ...

© 2016-2024 Copyright www.tovenza.com

0.1385