Toyota Venza manuals

Toyota Venza: Installation

INSTALLATION

PROCEDURE

1. INSTALL FRONT POWER SEAT LUMBAR SWITCH

(a) Install the front power seat lumbar switch with the 2 screws.


2. INSTALL FRONT SEAT CUSHION SHIELD ASSEMBLY


3. INSTALL SLIDE AND VERTICAL POWER SEAT SWITCH KNOB


4. INSTALL RECLINING POWER SEAT SWITCH KNOB


5. INSTALL FRONT SEAT ASSEMBLY


6. INSTALL FRONT SEAT REAR INNER TRACK COVER


7. INSTALL FRONT SEAT REAR OUTER TRACK COVER


8. INSTALL FRONT SEAT HEADREST ASSEMBLY

9. INSPECT FRONT SEAT ASSEMBLY


10. INSPECT SRS WARNING LIGHT

(See page )


Inspection
INSPECTION PROCEDURE 1. INSPECT DRIVER SIDE LUMBAR SWITCH (a) Measure the resistance between the terminals when the switch is operated. Standard Resistance: Teste ...

Power Seat Switch
...

Other materials about Toyota Venza:

Initialization
INITIALIZATION 1. INITIALIZE SLIDING ROOF ECU (SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY) NOTICE: When the sliding roof glass, sliding roof housing or sliding roof ECU (sliding roof drive gear sub-assembly) is replaced or removed and installed, t ...

Removal
REMOVAL PROCEDURE 1. REMOVE REAR SEAT HEADREST ASSEMBLY (a) Press the headrest support button and pull up the headrest as shown in the illustration to remove it. 2. REMOVE REAR SEAT INNER TRACK ...

Adjustment
ADJUSTMENT CAUTION / NOTICE / HINT CAUTION: Before adjusting the door positions of vehicles equipped with side and curtain shield airbags, be sure to disconnect the battery. After adjustment, check that the SRS warning light is operating normally and ...

© 2016-2022 Copyright www.tovenza.com

0.1707