INSTALLATION
PROCEDURE
1. INSTALL LUMBAR SUPPORT ADJUSTER ASSEMBLY
(a) Install the bush. |
|
(b) Install the lumbar support adjuster assembly with the guide and 2 screws. |
|
(c) Connect the connector.
(d) Install the front seatback spring sub-assembly with the 8 guides and a new clamp. Text in Illustration
|
|
2. INSTALL SEPARATE TYPE FRONT SEATBACK COVER WITH PAD
3. INSTALL FRONT SEATBACK BOARD SUB-ASSEMBLY
4. INSTALL SEPARATE TYPE FRONT SEAT CUSHION COVER WITH PAD
5. INSTALL FRONT INNER SEAT CUSHION SHIELD
6. INSTALL FRONT SEAT INNER BELT ASSEMBLY
7. INSTALL POWER SEAT SWITCH
8. INSTALL FRONT SEAT CUSHION SHIELD ASSEMBLY
9. INSTALL SLIDE AND VERTICAL POWER SEAT SWITCH KNOB
10. INSTALL RECLINING POWER SEAT SWITCH KNOB
11. INSTALL FRONT SEAT ASSEMBLY
12. INSTALL FRONT SEAT REAR INNER TRACK COVER
13. INSTALL FRONT SEAT REAR OUTER TRACK COVER
14. INSTALL FRONT SEAT HEADREST ASSEMBLY
15. INSPECT FRONT SEAT ASSEMBLY
16. INSPECT SRS WARNING LIGHT
(See page )
On-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT DISCHARGE HEADLIGHT BULB
NOTICE:
Confirm the following items before replacing a discharge headlight bulb. If a
malfunction is discovered and repaired, perform the inspection again to confirm
the repair.
...
Removal
REMOVAL
PROCEDURE
1. PRECAUTION
CAUTION:
Be sure to read Precaution thoroughly before servicing (See page
).
If the front seat side airbag assembly was deployed, replace the front
seat side airbag assembly, front seat frame assembly wit ...
Transmission Wire(when Using The Engine Support Bridge)
Components
COMPONENTS
ILLUSTRATION
Installation
INSTALLATION
PROCEDURE
1. INSTALL TRANSMISSION WIRE
(a) Coat the O-ring with ATF.
(b) Coat the bolt with ATF.
(c) Install the transmission ...