Toyota Venza: Installation

Toyota Venza Service Manual / Seat / Front Seatback Heater / Installation

INSTALLATION

PROCEDURE

1. INSTALL SEPARATE TYPE FRONT SEATBACK COVER

(a) Using a tacker, install the separate type front seatback heater to the end of the separate type front seatback cover with 12 new tack pins.

NOTICE:

Be careful not to damage the cushion.

(b) Using hog ring pliers, install the separate type front seatback cover with 10 new hog rings.

Text in Illustration

*1	Hog Ring Pliers

NOTICE:

Be careful not to damage the separate type front seatback cover.
Be sure to securely install the hog rings as shown in the illustration while preventing wrinkles from forming on the separate type front seatback cover.

2. INSTALL SEPARATE TYPE FRONT SEATBACK COVER WITH PAD

3. INSTALL FRONT SEATBACK BOARD SUB-ASSEMBLY

4. INSTALL SEPARATE TYPE FRONT SEAT CUSHION COVER WITH PAD

5. INSTALL FRONT INNER SEAT CUSHION SHIELD

6. INSTALL FRONT SEAT INNER BELT ASSEMBLY

7. INSTALL POWER SEAT SWITCH

8. INSTALL FRONT SEAT CUSHION SHIELD ASSEMBLY

9. INSTALL SLIDE AND VERTICAL POWER SEAT SWITCH KNOB

10. INSTALL RECLINING POWER SEAT SWITCH KNOB

11. INSTALL FRONT SEAT ASSEMBLY

12. INSTALL FRONT SEAT REAR INNER TRACK COVER

13. INSTALL FRONT SEAT REAR OUTER TRACK COVER

14. INSTALL FRONT SEAT HEADREST ASSEMBLY

15. INSPECT FRONT SEAT ASSEMBLY

16. INSPECT SRS WARNING LIGHT

(See page )

Inspection

INSPECTION PROCEDURE 1. INSPECT FRONT SEATBACK HEATER LH (a) Apply battery voltage and check the seatback heater. OK: Measurement Connection Cond ...

Lumbar Support Adjuster Assembly

...

Other materials about Toyota Venza:

Tire Pressure Warning Ecu
Components COMPONENTS ILLUSTRATION ILLUSTRATION Removal REMOVAL CAUTION / NOTICE / HINT NOTICE: Before removing the tire pressure warning ECU, read the registered transmitter IDs of all wheels and write them down to use for re-registration of ...

High Temperature Adjustment
HIGH TEMPERATURE ADJUSTMENT PROCEDURE 1. ADJUST FLUID LEVEL AT HIGH TEMPERATURE CAUTION: Use caution while the engine is idling and the cooling fan is operating. Be careful not to burn yourself when the automatic transaxle fluid temperature ...

Disassembly
DISASSEMBLY PROCEDURE 1. REMOVE FUEL SENDER GAUGE 2. SEPARATE FUEL SUCTION PLATE SUB-ASSEMBLY (a) Disconnect the fuel pump connector from the fuel suction plate. NOTICE: Do not damage the wire harness. ...