INSTALLATION
PROCEDURE
1. INSTALL SEPARATE TYPE FRONT SEAT CUSHION COVER
(a) Using a tacker, install the separate type front seat cushion heater to the end of the separate type front seat cushion cover with 25 new tack pins. NOTICE: Be careful not to damage the cushion. |
|
(b) Using hog ring pliers, temporarily install the separate type front seat cover with 18 new hog rings. Text in Illustration
NOTICE:
|
|
2. INSTALL SEPARATE TYPE FRONT SEAT CUSHION COVER WITH PAD
3. INSTALL POWER SEAT SWITCH
4. INSTALL FRONT INNER SEAT CUSHION SHIELD
5. INSTALL FRONT SEAT INNER BELT ASSEMBLY
6. INSTALL FRONT SEAT CUSHION SHIELD ASSEMBLY
7. INSTALL SLIDE AND VERTICAL POWER SEAT SWITCH KNOB
8. INSTALL RECLINING POWER SEAT SWITCH KNOB
9. INSTALL FRONT SEAT ASSEMBLY
10. INSTALL FRONT SEAT REAR INNER TRACK COVER
11. INSTALL FRONT SEAT REAR OUTER TRACK COVER
12. INSTALL FRONT SEAT HEADREST ASSEMBLY
13. INSPECT FRONT SEAT ASSEMBLY
14. INSPECT SRS WARNING LIGHT
(See page )
Fail-safe Chart
FAIL-SAFE CHART
Engine Coolant Temperature Gauge
Condition
Response
Recovery
Engine coolant temperature data is interrupted for 3 seconds.
The gauge needle indicates below C.
Engine cool ...
Problem Symptoms Table
PROBLEM SYMPTOMS TABLE
Use the table below to help determine the cause of problem symptoms. If multiple
suspected areas are listed, the potential causes of the symptoms are listed in order
of probability in the "Suspected Area" column of the tab ...
Replacement
REPLACEMENT
PROCEDURE
1. REPLACE RING PIN
NOTICE:
It is not necessary to remove the ring pin unless it is being replaced.
(a) Remove the 12 ring pins.
(b) Using a plastic-faced hammer, install 12 new ring pins.
Standard Protrusion Height:
...