Toyota Venza manuals

Toyota Venza: Installation

INSTALLATION

PROCEDURE

1. INSTALL FRONT SEAT ASSEMBLY

(a) Place the front seat assembly in the cabin.

NOTICE:

Be careful not to damage the vehicle body.

(b) Connect each connector under the front seat assembly.

(c) Connect the cable to the negative (-) battery terminal.

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).


(d) Temporarily install the front seat assembly with the 4 bolts.

(e) Operate the slide and vertical power seat switch knob and move the seat to the rearmost position.

(f) Tighten the 2 bolts on the front side of the front seat assembly.

Torque:

37 N·m {377 kgf·cm, 27 ft·lbf}

HINT:

Tighten the bolts in the order shown in the illustration.


(g) Operate the slide and vertical power seat switch knob and move the front seat assembly to the foremost position.

(h) Tighten the 2 bolts on the rear side of the front seat assembly.

Torque:

37 N·m {377 kgf·cm, 27 ft·lbf}

HINT:

Tighten the bolts in the order shown in the illustration.


2. INSTALL FRONT SEAT REAR INNER TRACK COVER

(a) Engage the 2 claws to install the front seat rear inner track cover.


3. INSTALL FRONT SEAT REAR OUTER TRACK COVER

(a) Engage the 2 claws to install the front seat rear outer track cover.


4. INSTALL FRONT SEAT HEADREST ASSEMBLY

5. INSPECT FRONT SEAT ASSEMBLY

(a) Inspect the power seat operation.

(b) w/ Seat Heater System:

Check the seat heater operation.

(1) Turn the ignition switch to ON.

(2) Turn the seat heater switch on.

(3) Wait 5 minutes or more and confirm that the seat surface becomes warm.

6. INSPECT SRS WARNING LIGHT

(See page )


Reassembly
REASSEMBLY PROCEDURE 1. INSTALL FRONT SEAT WIRE RH (for Front Passenger Side) (a) Engage each clamp and install the front seat wire RH. 2. INSTALL OCCUPANT CLASSIFICATION ECU (for Front Passenger ...

Front Seat Cushion Heater
...

Other materials about Toyota Venza:

Steering Pad Switch Circuit
DESCRIPTION This circuit sends an operation signal from the steering pad switch assembly to the radio and display receiver assembly. If there is an open in the circuit, the audio system cannot be operated using the steering pad switch assembly. If there ...

Security Indicator Light Circuit
DESCRIPTION The security indicator light blinks continuously due to a continuous signal received from the transponder key ECU assembly while in the armed state. WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE: If the transponder key ECU assembly is repl ...

Pressure Control Solenoid "G" Electrical (Shift Solenoid Valve SL4) (P2810)
DESCRIPTION Changing from 1st to 6th is performed by the TCM turning shift solenoid valves SL1, SL2, SL3, SL4 and SL on and off. If an open or short circuit occurs in any of the shift solenoid valves, the TCM controls the remaining normal shift solenoid ...

© 2016-2024 Copyright www.tovenza.com

0.1137