INSTALLATION
PROCEDURE
1. INSTALL DRIVE MONITOR SWITCH
(a) Engage the 4 claws to install the drive monitor switch.
2. INSTALL RADIO AND DISPLAY RECEIVER ASSEMBLY WITH BRACKET (for Radio and Display Type)
3. INSTALL NAVIGATION RECEIVER ASSEMBLY WITH BRACKET (for Navigation Receiver Type)
4. INSTALL NO. 2 INSTRUMENT PANEL SPEAKER PANEL SUB-ASSEMBLY
5. INSTALL CONSOLE BOX SUB-ASSEMBLY
6. INSTALL POSITION INDICATOR HOUSING ASSEMBLY
7. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY
8. INSTALL LOWER INSTRUMENT PANEL SUB-ASSEMBLY
9. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
10. INSTALL COWL SIDE TRIM SUB-ASSEMBLY RH
HINT:
Use the same procedure for the RH side and LH side (See page ).
11. INSTALL FRONT DOOR SCUFF PLATE RH
HINT:
Use the same procedure for the RH side and LH side (See page ).
12. INSTALL LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL
13. INSTALL COWL SIDE TRIM SUB-ASSEMBLY LH
14. INSTALL FRONT DOOR SCUFF PLATE LH
15. INSTALL AIR CONDITIONING CONTROL ASSEMBLY
16. INSTALL CONSOLE BOX ASSEMBLY
17. INSTALL NO. 2 CONSOLE BOX CARPET
18. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY (w/o Seat Heater System)
19. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY (w/ Seat Heater System)
Lost Communication with ECM / PCM (U0100)
DESCRIPTION
DTC No.
DTC Detection Condition
Trouble Area
U0100
No communication from the ECM continues.
ECM main wire or connector
Power source circuit of ECM
ECM
...
Reassembly
REASSEMBLY
PROCEDURE
1. INSTALL FRONT SEAT WIRE
(a) Engage the 2 clamps to install the front seat wire.
(b) Connect the 4 connectors.
2. INSTALL OCCUPANT CLASSIFICATION ECU
3. INSTALL FRONT LOW ...
Precaution
PRECAUTION
1. PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable from the negative (-) battery terminal, initialize
the following system(s) after the cable is reconnected.
System Name
...