Toyota Venza: Installation

Toyota Venza Service Manual / Lighting (int) / Rear Door Courtesy Switch / Installation

INSTALLATION

PROCEDURE

1. INSTALL REAR DOOR COURTESY LIGHT SWITCH

(a) Using "TORX" socket wrench T30, install the rear door courtesy light switch with the "TORX" bolt.

Torque:

8.0 N·m {82 kgf·cm, 71 in·lbf}

(b) Connect the rear door courtesy light switch connector.

2. INSTALL DECK TRIM SIDE PANEL ASSEMBLY LH (for LH Side)

3. INSTALL DECK TRIM SIDE PANEL ASSEMBLY RH (for RH Side)

4. CONNECT REAR SEAT OUTER BELT ASSEMBLY

5. INSTALL LUGGAGE HOLD BELT STRIKER ASSEMBLY

6. INSTALL RECLINING REMOTE CONTROL BEZEL

7. INSTALL REAR SEAT ASSEMBLY LH (for LH Side)

8. CONNECT REAR SEAT NO. 2 RECLINING CONTROL CABLE SUB-ASSEMBLY (for LH Side)

9. INSTALL REAR SEAT OUTER TRACK BRACKET COVER (for LH Side)

10. INSTALL REAR SEAT INNER TRACK BRACKET COVER (for LH Side)

11. INSTALL REAR SEAT HEADREST ASSEMBLY (for LH Side)

12. INSTALL REAR SEAT ASSEMBLY RH (for RH Side)

13. CONNECT REAR SEAT RECLINING CONTROL CABLE SUB-ASSEMBLY (for RH Side)

14. INSTALL REAR SEAT OUTER TRACK BRACKET COVER (for RH Side)

15. INSTALL REAR SEAT INNER TRACK BRACKET COVER (for RH Side)

16. INSTALL REAR SEAT CENTER HEADREST ASSEMBLY (for RH Side)

17. INSTALL REAR SEAT HEADREST ASSEMBLY (for RH Side)

18. INSTALL REAR FLOOR FINISH PLATE

19. INSTALL REAR SEAT SUB FLOOR PANEL ASSEMBLY

20. INSTALL NO. 1 DECK BOARD

21. INSTALL DECK SIDE TRIM BOX LH

22. INSTALL NO. 3 DECK BOARD SUB-ASSEMBLY

23. INSTALL DECK SIDE TRIM BOX RH

24. INSTALL NO. 2 DECK BOARD SUB-ASSEMBLY

25. INSTALL DECK BOARD ASSEMBLY

26. INSTALL TONNEAU COVER ASSEMBLY (w/ Tonneau Cover)

27. CONNECT REAR DOOR OPENING TRIM WEATHERSTRIP

28. INSTALL REAR DOOR SCUFF PLATE

Inspection

INSPECTION PROCEDURE 1. INSPECT COURTESY LIGHT SWITCH (a) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Swit ...

Relay

On-vehicle Inspection ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT DOME CUT RELAY (a) Measure the resistance according to the value(s) in the table below. Standard Resistance: ...

Other materials about Toyota Venza:

Removal
REMOVAL CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH side and LH side. The procedure listed below is for the LH side. PROCEDURE 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL CAUTION: Wait at least 90 seconds aft ...

Installation
INSTALLATION PROCEDURE 1. INSTALL FRONT SUSPENSION MEMBER BODY MOUNTING REAR CUSHION LH (a) Temporarily install a new front suspension member body mounting rear cushion LH while confirming the installation direction. NOTICE: Position th ...

Installation
INSTALLATION PROCEDURE 1. INSTALL THROTTLE BODY ASSEMBLY (a) Install a new gasket to the intake manifold. (b) Install the fuel tube bracket with the bolt. Torque: 7.5 N·m {76 kgf� ...