Toyota Venza: Installation

Toyota Venza Service Manual / Interior Panels / Trim / Front Console Box / Installation

INSTALLATION

PROCEDURE

1. INSTALL CONSOLE BOX ASSEMBLY

(a) Connect the connectors.

(b) Engage the 2 claws.

(d) Install the console box assembly with the 2 bolts.

2. INSTALL NO. 2 CONSOLE BOX CARPET

(a) Install the No. 2 console box carpet.

3. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY (w/o Seat Heater System)

4. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY (w/ Seat Heater System)

Removal

REMOVAL PROCEDURE 1. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY (w/o Seat Heater System) 2. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY (w/ Seat Heater System) 3. REMOVE NO. 2 CONSOLE BOX CARPET ...

Reassembly

REASSEMBLY PROCEDURE 1. INSTALL REAR CONSOLE ARMREST ASSEMBLY (a) Temporarily install the rear console armrest assembly. (b) Push in the box door hinge shafts by hand as far as possible ...

Other materials about Toyota Venza:

Horn
Components COMPONENTS ILLUSTRATION Inspection INSPECTION PROCEDURE 1. INSPECT LOW PITCHED HORN ASSEMBLY (a) Apply battery voltage and check the operation of the low pitched horn assembly according to the table below. OK: ...

How To Proceed With Troubleshooting
CAUTION / NOTICE / HINT HINT: Use the following procedure to troubleshoot the engine immobiliser system. *: Use the Techstream. PROCEDURE 1. VEHICLE BROUGHT TO WORKSHOP NEXT ...

Terminals Of Ecu
TERMINALS OF ECU 1. POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY (a) Disconnect the I6 power window regulator master switch assembly connector. (b) Measure the voltage and resistance according to the value(s) in the table below. HINT: Measure the val ...