Toyota Venza: Installation

Toyota Venza Service Manual / Door Lock / Door Control Receiver / Installation

INSTALLATION

PROCEDURE

1. INSTALL DOOR CONTROL RECEIVER

(a) Install the door control receiver with the bolt.

(b) Connect the connector.

2. INSTALL ROOF SIDE INNER GARNISH ASSEMBLY RH

HINT:

Use the same procedure for the RH side and LH side (See page ).

3. INSTALL DECK TRIM SIDE PANEL ASSEMBLY RH

4. CONNECT REAR SEAT OUTER BELT ASSEMBLY

HINT:

Use the same procedure for the RH side and LH side (See page ).

5. INSTALL LUGGAGE HOLD BELT STRIKER ASSEMBLY

HINT:

Use the same procedure for the RH side and LH side (See page ).

6. INSTALL RECLINING REMOTE CONTROL BEZEL

HINT:

Use the same procedure for the RH side and LH side (See page ).

7. INSTALL REAR SEAT ASSEMBLY RH

8. CONNECT REAR SEAT RECLINING CONTROL CABLE SUB-ASSEMBLY

9. INSTALL REAR SEAT OUTER TRACK BRACKET COVER RH

10. INSTALL REAR SEAT INNER TRACK BRACKET COVER RH

11. INSTALL REAR SEAT CENTER HEADREST ASSEMBLY

12. INSTALL REAR SEAT HEADREST ASSEMBLY RH

13. INSTALL REAR FLOOR FINISH PLATE

14. INSTALL REAR SEAT SUB FLOOR PANEL ASSEMBLY

15. INSTALL NO. 1 DECK BOARD

16. INSTALL DECK SIDE TRIM BOX LH

17. INSTALL NO. 3 DECK BOARD SUB-ASSEMBLY

18. INSTALL DECK SIDE TRIM BOX RH

19. INSTALL NO. 2 DECK BOARD SUB-ASSEMBLY

20. INSTALL DECK BOARD ASSEMBLY

21. INSTALL TONNEAU COVER ASSEMBLY (w/ Tonneau Cover)

22. CONNECT REAR DOOR OPENING TRIM WEATHERSTRIP RH

23. INSTALL REAR DOOR SCUFF PLATE RH

HINT:

Use the same procedure for the RH side and LH side (See page ).

Removal

REMOVAL PROCEDURE 1. REMOVE REAR DOOR SCUFF PLATE RH HINT: Use the same procedure for the RH side and LH side (See page ). 2. DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP RH HINT: Use the s ...

Door Control Switch

Components COMPONENTS ILLUSTRATION Inspection INSPECTION PROCEDURE 1. INSPECT DOOR CONTROL SWITCH ASSEMBLY (a) Measure the resistance according to the value(s) in the table bel ...

Other materials about Toyota Venza:

Data Signal Circuit between Radio Receiver and Extension Module
DESCRIPTION The stereo component tuner assembly sends the image data signal to the radio and display receiver assembly via this circuit. WIRING DIAGRAM PROCEDURE 1. CHECK NAVIGATION WIRE (a) Remove the navigation wire ( ...

ECU Power Source Circuit
DESCRIPTION This circuit provides power for main body ECU (driver side junction block assembly) operation. WIRING DIAGRAM PROCEDURE 1. CHECK DRIVER SIDE JUNCTION BLOCK ASSEMBLY (MAIN BODY ECU (POWER SOURCE)) ...

Rear Airbag Sensor LH Circuit Malfunction (B1635/24)
DESCRIPTION The side collision sensor LH circuit (to determine deployment of the front seat side airbag assembly LH and curtain shield airbag assembly LH) is composed of the center airbag sensor assembly, rear airbag sensor LH and side airbag sensor LH. ...