Toyota Venza: Installation
INSTALLATION
PROCEDURE
1. INSTALL WINDSHIELD WIPER SWITCH ASSEMBLY
|
(a) Engage the claw to install the windshield wiper switch assembly as shown in the illustration. |
|
(b) Connect the 2 connectors.
2. INSTALL UPPER STEERING COLUMN COVER
|
(a) Engage the 3 claws and 4 clips to install the upper steering column cover to the lower instrument cover. |
|
.png)
3. INSTALL LOWER STEERING COLUMN COVER
|
(a) Engage the 3 claws to install the lower steering column cover to the upper steering column cover. |
|
.png)
|
(b) Turn the steering wheel assembly to the left and install the screw shown in the illustration. |
|
.png)
|
(c) Turn the steering wheel assembly to the right and install the screw shown in the illustration. |
|
.png)
4. INSTALL LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL
.gif)
5. INSTALL COWL SIDE TRIM SUB-ASSEMBLY LH
6. INSTALL FRONT DOOR SCUFF PLATE LH
Inspection
INSPECTION
PROCEDURE
1. INSPECT WINDSHIELD WIPER SWITCH ASSEMBLY
(a) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Front Wiper Switch
...
Door Lock
...
Other materials about Toyota Venza:
Internal Control Module EEPROM Error (P062F)
DESCRIPTION
The TCM monitors its internal operation and it will set this DTC when it detects
an internal malfunction.
DTC No.
DTC Detection Condition
Trouble Area
P062F
TCM internal error (EEPROM ...
Panel Switches do not Function
PROCEDURE
1.
CHECK PANEL SWITCH
(a) Check for foreign matter around the switches that might prevent operation.
OK:
No foreign matter is found.
NG
REMOVE ANY FOREIGN MATTER FOUND
...
Removal
REMOVAL
PROCEDURE
1. REMOVE REAR WHEELS
2. REMOVE CENTER EXHAUST PIPE ASSEMBLY
(a) Remove the center exhaust pipe assembly.
HINT:
Refer to the instructions for Removal of the exhaust pipe (See page
for 2GR-FE,
for 1AR-FE).
3. REMOVE PROPELLER WITH ...
0.1406