INSTALLATION
PROCEDURE
1. INSTALL REAR WIPER MOTOR AND BRACKET ASSEMBLY
(a) Install the rear wiper motor and bracket assembly with the 3 bolts. Torque: 5.5 N·m {56 kgf·cm, 49 in·lbf} |
|
(b) Connect the connector.
2. INSTALL REAR WIPER MOTOR GROMMET
(a) Apply MP grease to the entire surface of the wiper motor grommet lip. Text in Illustration
HINT: Make sure that the hole does not get clogged with grease and the grooves on the lip are filled with grease. |
|
(b) Install the rear wiper motor grommet with the position mark facing upward as shown in the illustration. |
|
3. INSTALL REAR WIPER ARM AND BLADE ASSEMBLY
(a) Stop the wiper motor at the automatic stop position.
(b) When reusing the rear wiper arm and blade assembly:
(1) Clean the wiper arm serrations. Text in Illustration
|
|
(c) When reusing the rear wiper motor and bracket assembly:
(1) Clean the wiper pivot serrations with a wire brush. Text in Illustration
|
|
(d) Install the rear wiper arm and blade assembly with the nut to the position shown in the illustration. Standard Measurement
Torque: 5.5 N·m {56 kgf·cm, 49 in·lbf} |
|
(e) Operate the rear wiper while spraying washer fluid onto the back door glass. Make sure that the rear wiper functions properly and the wiper does not come into contact with the vehicle body.
4. INSTALL REAR WIPER ARM HEAD CAP
(a) Engage the 4 claws to install the cap as shown in the illustration. |
|
5. INSTALL BACK DOOR PANEL TRIM ASSEMBLY
Front Airbag Sensor RH Malfunction (B1610/13)
DESCRIPTION
The front airbag sensor RH circuit consists of the center airbag sensor assembly
and front airbag sensor RH.
The front airbag sensor RH detects impacts to the vehicle and sends signals to
the center airbag sensor assembly to determine if the ...
Parking brake
Sets the parking brake* (Depressing the pedal again releases the parking brake.)
*: Fully depress the parking brake pedal with your left foot while depressing
the brake pedal with your right foot.
- Usage in winter time
NOTICE
- Before driv ...
Installation
INSTALLATION
CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the RH side and LH side.
The procedure listed below is for the LH side.
PROCEDURE
1. INSTALL DOOR SIDE AIRBAG SENSOR
(a) Check that the ignition switch is off.
(b) C ...